KIOXI LTC10Z480GG8 SATA SSD User Guide
- June 9, 2024
- KIOXI
Table of Contents
KIOXI LTC10Z480GG8 SATA SSD
Instruction
Please be sure to check
personal.kioxia.com/support/ for the
latest firmware updates.
For Quick Start Guide, safety instructions, the latest drivers, and SSD
Utility Storage Management Software, please visit:
personal.kioxia.com/support/
Note: The following instructions are a general guideline for installing
the SSD and serve as a complement to your system’s owner manual.
LAPTOP INSTALLATION
-
Power off the system, disconnect all power cables, and remove the battery.
-
Locate the hard drive access panel; unscrew and remove the panel.
-
Disconnect and remove the existing storage drive from the drive bay (refer to your system’s user manual).
-
Remove all brackets and connectors from your existing storage drive and install them on the SSD (if necessary).
Note: If there is a proprietary connector and/or bracket on the existing storage drive, carefully remove it and connect it to the SSD. Systems will vary and these items may or may not be present. -
Insert the SSD into the drive bay while carefully aligning the SSD with the SATA* connectors.
-
Secure the SSD in the drive bay. Reinstall the access panel and insert the battery back into the system.
-
Power on your system to verify a successful installation. For a boot drive, this is signified by the BIOS prompting OS installation. For a secondary drive, follow the formatting instructions below.
Note: If the SSD will be your primary boot drive, please refer to your operating system’s user manual for further OS installation instructions. If this SSD will be used as a secondary drive, the drive must be formatted before use.
- SATA 6Gbit/s is backwards compatible with SATA 3Gbit/s. However, connecting a SATA 6Gbit/s device to a SATA 3Gbit/s connection will result in reduced performance.
DESKTOP INSTALLATION
- Power off the system and disconnect all power cables.
- Remove the system’s outer panel (refer to your system’s user manual).
- If your system provides a 2.5-inch drive bay(s), there is no need for a 3.5- inch adapter bracket.
- If your system does not provide a 2.5-inch drive bay(s), you will need to mount the SSD in a 2.5-inch to 3.5-inch adapter bracket.
- Install the SSD into an available drive bay.
- Connect one end of both the SATA* data cable and power cable to the SATA connectors on your motherboard and the remaining ends to your SSD.
- Reinstall the outer panel and reconnect the power cable to your PC.
- Power on your system to verify a successful installation.
Note: If the SSD will be your primary boot drive, please refer to your operating system’s user manual for further OS installation instructions. If this SSD will be used as a secondary drive, the drive must be formatted before use.
- SATA 6Gbit/s is backwards compatible with SATA 3Gbit/s. However, connecting a SATA 6Gbit/s device to a SATA 3Gbit/s connection will result in reduced performance.
DISPOSAL OF PRODUCTS
This symbol indicates that this product must not be treated as household
waste. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human health,
which could otherwise be caused by inappropriate waste handling of this
product. For more detailed information about recycling of this product, please
contact your local city office, your household waste disposal service or the
shop where you purchased the product.
EU Contact:
KIOXIA Europe GmbH,
Hansaallee 181, 40549 Düsseldorf, Germany
UK Contact :
KIOXIA Europe GmbH, Branch Office UK
31 Chertsey Street, Guildford, GU1 4HD, United Kingdom
Environmental labeling for packaging
Separate collection. Check your local municipal guidelines.
- Tray: Plastic (PET 1)
- Box: Paper (PAP 21
TECHNICAL SUPPORT
Need help?
Please contact us at our regional support page:
personal.kioxia.com/support/
FCC Information
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution
Changes or modifications made to this equipment, not expressly approved by
KIOXIA Corporation or parties authorized by KIOXIA Corporation could void the
user’s authority to operate the equipment.
FCC conditions
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
US Contact
- Name: KIOXIA America, Inc.
- Address: 2610 Orchard Parkway, San Jose, CA 95134, USA
- Phone: +1 408-526-2700
For Australia and New Zealand
Warranty Period: Three (3) years from date of Purchase.
How to Obtain Service: Your proof of purchase is required to receive warranty
service. If the Product fails during normal and proper use within its warranty
period, return the Product to your place of purchase for replacement or
refund. If your place of purchase is no longer trading contact the Support
Centre.
The return of your product will result in loss of any user-generated data. It
includes, but not limited to, for example: music, photos, videos, and other
electronic documents. Please ensure you have made a back-up copy of any data
saved on your product.
Consumer Guarantees (Australia only)
Our goods and services come with guarantees that cannot be excluded under the Australian Consumer Law. For major failures with the service, you are entitled:
- to cancel your service contract with us; and
- to a refund for the unused portion, or to compensation for its reduced value.
You are also entitled to choose a refund or replacement for major failures
with goods. If a failure with the goods or a service does not amount to a
major failure, you are entitled to have the failure rectified in a reasonable
time. If this is not done, you are entitled to a refund for the goods and to
cancel the contract for the service and obtain a refund of any unused portion.
You are also entitled to be compensated for any other reasonably foreseeable
loss or damage from a failure in the goods or service.
This Warranty is not intended to and does not limit your rights with respect
to the Consumer Guarantees (in Australia) or Consumer Guarantees Act (in New
Zealand).
Company names, product names, and service names may be trademarks of their
respective companies
© 2021 KIOXIA Corporation All rights reserved
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>