HYPERX HX437C19FB3K2/32 DDR4-3733 CL19 288-Pin DIMM Kit User Guide
- June 9, 2024
- HYPERX
Table of Contents
HYPERX HX437C19FB3K2/32 DDR4-3733 CL19 288-Pin DIMM Kit
DESCRIPTION
HyperX HX437C19FB3K2/32 is a kit of two 2G x 64-bit (16GB) DDR4-3733 CL19 SDRAM (Synchronous DRAM) 2Rx8, memory modules, based on sixteen 1G x 8-bit FBGA components per module. Each module kit supports Intel® Extreme Memory Profiles (Intel® XMP) 2.0. The total kit capacity is 32GB. Each module has been tested to run at DDR4-3733 at a low latency timing of 19-23-23 at 1.35V. The SPDs are programmed to JEDEC standard latency DDR4-2400 timing of 17-17-17 at 1.2V. Each 288-pin DIMM uses gold contact fingers. The JEDEC standard electrical and mechanical specifications are as follows:
FACTORY TIMING PARAMETERS
- Default (JEDEC): DDR4-2400 CL17-17-17 @1.2V
- XMP Profile #1: DDR4-3733 CL19-23-23 @1.35V
- XMP Profile #2: DDR4-3600 CL17-21-21 @1.35V
SPECIFICATIONS
- CL(IDD) 17 cycles
- Row Cycle Time (tRCmin) 45.75ns(min.)
- Refresh to Active/Refresh Command Time (tRFCmin) 350ns(min.)
- Row Active Time (tRASmin) 32ns(min.)
- UL Rating 94 V – 0
- Operating Temperature 0o C to +85o C
- Storage Temperature -55o C to +100o C
FEATURES
- Power Supply: VDD = 1.2V Typical
- VDDQ = 1.2V Typical
- VPP = 2.5V Typical
- VDDSPD = 2.2V to 3.6V
- On-Die termination (ODT)
- 16 internal banks; 4 groups of 4 banks each
- Bi-Directional Differential Data Strobe
- 8-bit pre-fetch
- Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)
- Height 1.3425” (34.1mm), w/heatsink
MODULE WITH HEAT SPREADER
MODULE DIMENSIONS
All measurements are in millimeters.
(Tolerances on all dimensions are ±0.12 unless otherwise specified).
The product images shown are for illustration purposes only and may not be an exact representation of the product. Kingston reserves the right to change any information at any time without notice.
FOR MORE INFORMATION, GO TOHYPERXGAMING.COM
All Kingston products are tested to meet our published specifications. Some
motherboards or system configurations may not operate at the published HyperX
memory speeds and timing settings. Kingstonthe published HyperX memory speeds
and timing settings. Kingston does not recommend that any user attempt to run
their computer does not recommend that any user attempt to run their computers
s faster than the published speed. Overclocking or modifying you’re faster
than the published speed. Overclocking or modifying your system timing may
result in damage to computer components. system timing may result in damage to
computer components.
HyperX is a division of Kingston.
©2019 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley,
CA 92708 USA.
All rights reserved. All trademarks and registered trademarks are the property
of their respective owners.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>