HARFO F02 Deadbolt with Fingerprint and Keypad Instruction Manual
- June 9, 2024
- HARFO
Table of Contents
HARFO F02 Deadbolt with Fingerprint and Keypad
Components list
Please check the above components carefully to make sure all items have been
received. If any items are missing, please contact Customer Service (See page
for contact information).
Please read this manual carefully before installing and operating!
Tools Required
- Phillips screwdriver
- Tape measure
Installation Guide
Assembly Diagram
Check The Door’s Dimension
- Measure to confirm the thickness of the door is between 1-3/8” and2 1/8”(35~54mm).
- Measure to confirm the diameter of the hole in the door is 2 1/8” (54mm).
- Measure to confirm the backset (as shown below) is either 2-3/8” (60mm) or 2-3/4”(70mm).
- Measure to confirm the diameter of the hole in the door edge is 1” (25mm).
Install Deadbolt and Strike
-
Set the Deadbolt backset to 60mm(2-3/8”) or 70mm(2-3/4”) to fit your
door hole. -
Insert the Deadbolt into the door hole, and tighten Screw A to fix the blot. Install Striker Box and Striker Plate also with Screw A into the door frame.
Install Exterior Panel
-
Keep the Deadbolt retracted and the Spindle of the Exterior Panel
horizontal, install the Exterior Panel by aligning the Spindle with the hole of the Deadbolt. -
Make sure the cable go through the hole of the door under the Deadbolt.
Install Interior Panel
-
Route the cable through the hole on the lower side of the Interior mounting plate.
-
Secure the Interior mounting plate with Screw B.
-
For right-hinged doors, keep the knob in a horizontal position; For left-hinged doors, keep the knob in a vertical position before moving to the next step.
-
Insert the connector of the cable into the socket on the Interior panel firmly, put the excess wire into the door, and secure the Interior panel with the Interior mounting plate together with 3 Screw C.
Install Batteries
- Insert 4 AA batteries and install battery cover
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment
The devices has been evaluated to meet general RF exposure requirement， the
device can be used in portable exposure condition without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>