STANFOR LT40 Replacement Bulb Instruction Manual
- June 9, 2024
- STANFOR
Table of Contents
LT40 Replacement Bulb
Instruction Manual
Instruction Manual
Model: LT40
LT40 Replacement Bulb
Technical specifications:
– Standard input voltage: 12V DC
– Standard input wattage: LT40 – 8W
– CCT (Correlated Colour Temperature) (K): 6,500
– Colour rendering (Ra): 80
– Maximum water temperature: 50°C (122°F)
– Non-dimmable
This bulb is compatible with most standard PAR56 pool lights. The bulb should be installed inside a niche which meets IP68 certification, and be connected via an independent transformer with an output of 12V DC.
WARNING!
- This light bulb is not intended for use by someone with reduced physical, sensory or mental capabilities or a lack of experience and knowledge unless they have been given instructions concerning the appliance and are under supervision of the person responsible for their safety.
- Prior to installing the bulb, read and follow all warning notices and instructions accompanying your niche. Failure to heed safety warnings and instructions could result in severe injuries, death, and/or property damage.
- Installation, repair, and maintenance must always be carried out only when the niche / bulb is disconnected from the power supply.
- Improper installation could result in electrical hazards – causing serious injuries, death, as well as damages to nearby properties.
- Avoid contact with the electric voltage when you install the lamp.
- Do not handle the bulb with wet limbs.
- If the external cable or cord of the niche is damaged, it must be replaced immediately by an authorized service agent before the bulb is replaced.
- The bulb should not be powered by a voltage higher than 12V DC.
- The pool should be unoccupied as the bulb is replaced.
- Do not operate the bulb outside of water.
INSTALLATION
- Do not install the bulb if the original niche has been damaged or is distorted due to overheating.
- Make sure the original bulb has cooled prior to replacing it with a new one.
-
Disconnect the power supply from the bulb.
-
Make sure the pool is not in use.
-
Remove the niche from the fixture housing on the pool wall in accordance with niche manufacturer’s instructions. Make sure the cable length is long enough for the niche to be placed on the pool deck. Otherwise, lower the water level to a point where it is below the niche.
-
Refer to niche instructions to dismantle the niche and remove existing bulb.
-
Remove the wire connector from the bulb.
-
If necessary, use an abrasive paper to remove visible limescale deposits from the wire connector.
-
Replace the bulb and connect the wire. Make sure the wire connector is secured under the screw of the bulb terminal.
WARNING! Do not install the bulb if the original niche housing is visibly damaged or distorted. -
Replace with a new niche O-ring if necessary. Contact your niche dealer for proper O-ring issuance.
-
Make sure all required O-ring(s) are installed correctly.
WARNING! Failure to do so may result in water leakage, potentially causing an electrical hazard that might result in serious injuries, death, as well as damages to nearby properties. -
Fix the niche and securely re-install it to the fixture housing.
-
Make sure the water level is above the niche prior to initiating operation.
-
Turn on the power supply.
Environmental Programmed, WEEE European Directive
Please respect the European Union regulations and help to protect the
environment.
Return non-working electrical equipment to a facility appointed by your
municipality that properly recycles electrical and electronic equipment. Do
not dispose them in unsorted waste bins.
For items containing removable batteries, remove batteries before disposing of
the product.
Manufacturer / Fabricant / Fabricate:
Koki do Development Ltd. 1319,
27 Sheng Yip St., Kwun Tong, HK.
PAR56 Replacement Bulb
Made in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>