DOMO DO42101SV 2 In 1 Stick Vacuum Cleaner Instruction Manual
- June 9, 2024
- DOMO
Table of Contents
DOMO DO42101SV 2 In 1 Stick Vacuum Cleaner
SAFETY INSTRUCTIONS
- This appliance may be used by children from the age of 8 and up, and also by persons with a physical or sensorly limitation, as well as mentally limited persons or persons with a lack of experience and knowledge. But only on the condition that these persons have received the necessary instructions on how to use this appliance in a safe way and know the dangers that can occur by using this appliance.
- Children cannot be allowed to play with the appliance.
- Maintenance and cleaning of the appliance may not be done by children, unless they are older than 8 years old and are under supervision. Keep the appliance out of reach of children younger than 8 years old.
- Attention: This appliance cannot be used with an external timer or a separate remote control.
- Read all instructions before use.
- Before use, check if the voltage stated on the appliance corresponds with the voltage of the power net at your home.
- Do not let the cord hang on a hot surface or on the edge of a table or counter top.
- Never use the appliance when the cord or plug is damaged, after malfunction or when the appliance itself is damaged. In that case, take the appliance to the nearest qualified service center for check-up and repair.
- Close supervision is necessary when the appliance is used near or by children.
- The use of accessories that are not recommended or sold by the manufacturer can cause fire, electrical shock or injuries.
- Never place this appliance near a gas stove or electrical stove or in a place where it may come into contact with a warm appliance.
- Do not use the appliance outdoors.
- Only use the appliance for its intended use.
- Always use the appliance on a steady, dry and level surface.
- Only use the appliance for domestic use. The manufacturer can not be held responsible for accidents that result from improper use of the appliance or not following the instructions described in this manual.
- All repairs should be carried out by the manufacturer or its aftersales service.
- Never immerse the appliance, the cord or the plug in water or any other liquid.
- Make sure that children do not touch the cord or appliance.
- Keep the cord away from sharp edges and hot parts or other heat sources.
- Before use, remove all packaging materials and any promotional stickers.
- Do not use the vacuum cleaner to vacuum up detergents, liquids, needles, matches and other similar liquids, sharp objects or flammable objects.
- Do not use the vacuum cleaner to vacuum up cement, powder and other small particles.
- Also avoid vacuuming up large objects. The vacuum cleaner could be clogged, the motor could overheat or other damage may occur.
- Make sure that the air intake or the floor suction opening do not become blocked.
- Make sure that the machine does not come into contact with liquids.
- First charge a new battery up completely.
- Pull the plug from the outlet when the vacuum cleaner is fully charged.
- Do not use the vacuum cleaner to vacuum up detergents, liquids, needles, matches and other similar liquids, sharp objects or flammable objects.
- Do not use the vacuum cleaner to vacuum up cement, powder and other small particles. Also avoid vacuuming up large objects. The vacuum cleaner could be clogged, the motor could overheat or other damage may occur.
- Make sure that the air intake or the floor suction opening do not become blocked.
- Make sure that the machine does not come into contact with liquids.
- First charge a new battery up completely.
- Pull the plug from the outlet when the vacuum cleaner is fully charged.
- This product contains a rechargeable battery. Batteries should be recycled. Do not drill into the battery or expose it to high temperatures; the battery could explode.
- Under extreme circumstances, there could be leakage of the battery. If the liquid from the battery comes into contact with the skin, wash it off immediately with water and soap or neutralize it with a mild acid such as lemon juice or vinegar. If the liquid comes into contact with the eyes, rinse them liberally with water for at least 10 minutes and contact a doctor.
- Do not place foreign objects in the openings of your machine. Do not use the machine if an opening is blocked. Keep the machine free from dust, dirt, hair or anything that could reduce the air supply.
- Remove large and sharp objects from the floor to prevent damage to the plastic components, the brushes and the motor.
- Keep hair, loose clothing, fingers and other body parts away from openings and moving parts.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
PARTS
- A. Handle
- B. On/off button
- C. Speed control
- D. Button to bend the handle
- E. Release button hand-held cleaner
- F. Handle of hand-held vacuum cleaner
- G. On/off button hand-held cleaner
- H. Air outlet
- I. Unlock button for dust reservoir
- J. Dust reservoir
- K. Release button floor nozzle
- L. Floor wheels
- M. Floor nozzle with LED lights
- N. Hand-held vacuum cleaner
- O. Battery charge indicator
- P. Dust brush
- Q. Crevice vacuum cleaner
- R. Charging adaper with cable
BEFORE THE FIRST USE
To set up the machine properly, please follow the steps below:
- Straighten the handle of the stick vacuum until it clicks into position.
- Make sure that the floor nozzle is clicked on tightly to the stick vacuum cleaner.
- Assemble the vacuum cleaner to contain filters – never use without filters.
CHARGING
- Completely assembled appliace you can start charging the vacuum cleaner.
- The handheld vacuum cleaner must be inserted in the stick vacuum cleaner.
- Attach the charger to the in-built connector.
- Put the stick vacuum cleaner near the socket and connect it. Make sure it all is stable.
- The battery level indicator will now light up and indicate when the machine is fullycharged.
- When fully charged, the lights go out – charging complete. If you switch on the vacuum cleaner, all the indicators (full scale) will light up.
USE
- Press the on-off switch on the handle to turn the machine on. When you switch on the machine, the rotating floor brush at the bottom of the floor nozzle will begin to turn. This will cause the dirt in the opening to be shifted and thereby vacuumed up. The dirt will be collected in the dust reservoir of the hand-held vacuum cleaner.
- Press the speed control to increase or lower the suction power.
- Press the release button on the hand-held vacuum cleaner to remove the hand-held vacuum cleaner and only use the hand-held vacuum cleaner.
- To use just the hand-held vacuum, press the on-off switch on the hand-held vacuum cleaner.
- The machine is equipped with a safety which will ensure that the machine shuts itself off if, for example, objects which are too large are sucked up, or if fingers become tangled in the floor brush. This is for personal safety and to protect the motor. To reverse the floor brush, press the on/off button again or press the speed control.
CLEANING AND MAINTENANCE
- Before cleaning switch off the appliance and make sure that it is not plugged in.
- Never attempt to clean the device or its parts with solvents, petrol or abrasives that could damage the surface of the device.
- Before using the vacuum cleaner, make sure that all components are correctly assembled.
- Always use a vacuum cleaner with all filters. If all filters are not properly seated and cleaned, you may lose suction power or damage the engine.
- Do not put the filters in the dishwasher or in the washing machine. Do not use a hair dryer to dry.
CLEANING THE DUST RESERVOIR
- Remove the hand-held vacuum cleaner from the stick vacuum and press the release button on the dust reservoir on the hand-held vacuum cleaner.
- Remove the dust reservoir from the motor section. Then take the filters out of the dust reservoir.
- Empty the dust reservoir. The dust reservoir, the filter and the HEPA filter can be cleaned under running water. Do take care to dry them completely before using them again in the machine. We advise replacing the filters regularly to ensure an optimal operation of the machine. Dirty filters will reduce the suction power drastically. After every cleaning, clean the dust reservoir and the filters to extend the life span of your machine.
CLEANING THE FLOOR BRUSH
- Remove the floor nozzle from the upright vacuum cleaner. Press the release button at the back of the floor nozzle and remove it from the machine.
- Click on the release button on the left of the floor brush.
- Remove the rotating floor brush from the floor nozzle. Remove hairs and other dirt that have wrapped around the floor brush. If you do not clean the floor brush regularly, it will become damaged and your machine will become unusable.
- The rotating floor brush may be rinsed off under running water. Make sure that it is completely dry before using it.
- Place the floor brush back into the floor nozzle when it is clean. Click the closure valve back into place to close it.
- Push the nozzle back onto the stick. The machine is now again ready for use.
Note: Stuck hairs can damage the machine or your floor. Always remove the hairs stuck on the brushes.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>