UGREEN CM596 Car Bluetooth Audio Receiver User Manual
- June 9, 2024
- UGREEN
Table of Contents
Car Bluetooth Audio Receiver Model: CM596 I P/N: 90748
User Manual
Package Contents
Product Overview
- 3 5mm Audio
- Reset Button
- MFB Button: Power On/Power Off/Pairing/Factory Reset/Reconnect-ing/Take a Call/End a call/Reject a Call/Play/Pause
- Indicator
- Volume Up/Previous I rack
- USB-C Power Supply
- Volume Down/Next Track
- Mic
Operation
| Button | Function | Operation |
|---|---|---|
| Power on/Power off | Press and hold for 3s | |
| Play/Pause | Short press once | |
| Take a call | Short press once | |
| End a call | Press twice | |
| Reject a call | Press and hold for 2s | |
| Factory reset | (Power off) Press and hold for lOs |
Language switching
for voice prompts| (Pairing) Press 3 times
| Volume up| Short press once
Previous track| Press and hold for 2s
| Volume down| Short press once
Next track| Press and hold for 2s
| Reset (Force shutdown)| Short press once
Bluetooth Pairing
- Press and hold the MFB button for 3s till you hear the voice prompt “Power on”. The blue indicator will be on for is when it’s powered on.
- It will automatically enter pairing mode when the indicator flashes red and blue alternately.
- Turn on the Bluetooth, search “Ugreen-90748” and connect. The voice prompt of “Connected” indicates the connection is established.
- Press and hold the MFB button for 3s to power it off, at this point, you will hear the voice prompt “Power off”.
- When used again, the receiver will auto-connect to the device used last time.
Dual Connectivity
- Connect the receiver to Phone A (Please refer to [Bluetooth Pairing]), then turn off Bluetooth on Phone A once connected.
- Connect the product to Phone B.
- Turn on the Bluetooth of phone A, this receiver will reconnect to phone A automatically.
- Finally, both Phone A and Phone B are connected to the product simultaneously.
Notes
If the Bluetooth connAction fails, please follow the steps below:
- Make sure the receiver and mobile phone don’t connect to other Bluetooth devices.
- If it fails repeatedly, please restart the receiver.
- Factory reset:
When pAXower is off, press and hold the MFB button for lOs to delete pairing information. The indicator will be on for 5s when resetting succeed.
Battery Level and Charging
- Battery level: It will show on the status bar of your mobile phone (Not available for all phones).
- Low battery signs: A voice prompt of “Battery low” indicates that the battery is less than 10%, please charge it in time.
LED Indicator Light Status & Voice Prompts
| Operation | Status | LED Indicator | Voice Prompts |
|---|---|---|---|
| Power on/Power off | Power on | Blue Indicator on: is | Power on |
| Power off | Red Indicator on: is | Power off | |
| Power off after 5-minute no connection | Red Indicator on: is | Pairing fail, |
Power off
Factory reset| Blue Indicator on: 5s| /
Bluetooth connection| Pairing| Red and blue Indicator flash alternately| /
Pairing successful| Blue Indicator blinks every lOs| Connected
Disconnected| Red and blue Indicator flash alternately| Disconnected
Reconnecting| Blue Indicator blinks every 5s| /
Dual connectivity| Blue Indicator Blu blinks every lOs| Connected
rvlusic/Calls| Play| Blue Indicator quickly blinks twice every lOs| /
Pause| Blue Indicator blinks every lOs| /
Incoming call notification| Blue Indicator blinks every 3s| /
Battery| Battery low| Red Indicator blinks every lOs| Battery low
Charging| Solid red| /
Fully charged| Power on: Red indicator off solid blue indicator
Power off: Red indicator off| /
Language switching| Voice prompts| Red and blue Indicator flash alternately|
English
Specifications
- Model: CM596
- Bluetooth Version: 5.1
- Bluetooth Protocol: AVRCP/A2DP/HFP/HSP
- Input: 3.5mm Audio
- Charging Port: USB-C
- Frequency Range: 2400MHz-2483.5MHz
- Frequency Response: 20Hz-20kHz
- Output Voltage: >0.7Vrms
- SNR: >90dB
- Codecs: SBC/AAC
- Battery: Lithium Polymer Battery
- Battery Capacity: 300mAh 3.7V (1.11Wh)
- Charging Limited Voltage: 5.25V
- Charging Time: About 2 Hours
- Runtime: About 15 Hours
- Transmission Distance: 15m/49ft (No Blocking)
Warnings
- The product contains Li-po battery, please do not dismantle, crush, squeeze, or expose it to fire.
- Stop using when it is swollen.
- Do not expose it to extreme temperatures.
- Stop using when the battery is submerged.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Warning Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environmentIhis transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter
FCC NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The devicecan be used in portable exposure condition without restriction.
IC Statement
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference; (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
WEEE
This symbol on the product(s) and / or accompanying documents indicates that,
under the new Directive 2012/19/EU on waste electrical and electronic
equipment (WEEE), product(s) used electrical and electronic equipment (WEEE)
should not be mixed with general household waste. For proper treatment,
recovery and recycling, please take this product(s) to designated collection
points where it will be accepted free of charge. Disposing of this product
correctly will help save valuable resources and prevent any potential negative
effects on human health and the environment, which could otherwise arise from
inappropriate waste handling. Please contact your local authority for further
details of your nearest designated collection point. Penalties may be
applicable for incorrect disposal of this waste, in accordance with your
national legislation.
For professional users in the European Union
If you wish to discard electrical and electronic equipment (EEE), please
contact your dealer or supplier for further information.
For disposal in countries outside of the European Union
This symbol is only valid in the European Union (EU). If you wish to discard
this product please contact your local authorities or dealer and ask for the
correct method of disposal.
EU Declaration of Conformity Hereby, Ugreen Group Limited declares that the product is in compliance with Directive 2014/53/EU & 2011/65/EU. Learn more about the EU Declaration of Conformity is available at the following Internet address: https://www.ugreen.com/download/
Ugreen Group Limited
Add- Ugreen Building, Longcheng Industrial Park, Longguanxi Road, Longhua,
Shenzhen, China
EU REP. Ugreen Group GmbH
Add- Mann heimer Str. 13, 30880
Laatzen, Germany
**** Declaration of Conformity
Hereby, Ugreen Group Limited declares that the product is in compliance with
Directive UK Radio Equipment Regulations(SI 2017 No.1206)& The Restriction of
the Use of Certain Hazardous Substances in Electrical and Electronic Equipment
Regulations 2012 (SI 2012 No.3032). Learn more about the GB Declaration of
Conformity is available at the following Internet address:
https://www.ugreen.com/download/
Ugreen Group Limited Add: Ugreen Building, Longcheng Industrial Park,
Longguanxi Road, Longhua, Shenzhen, China
UK REP:Acumen International Business Consultancy Limited
Add:94 Ock Street, Abingdon, OX14 5DH, UK
Warranty Information
A limited 2-year warranty applies to all UGREEN products purchased from UGREEN
official store or authorized sellers.
Please feel free to contact us if you run into any problems.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>