OLIGHT WARRIER X3 Tactical Flashlight User Manual

OLIGHT WARRIER X3 Tactical Flashlight

Thank you for purchasing this Olite Product. Please read this manual carefully before use and keep it for future reference!

IN THE BOX

• Warrior X 3 (With Battery and Warrior Ring)
  

• USB Magnetic Charging Cable

  ---

• Silicone Tactical Grip Ring

  ---

• Holster
  

SPECIFICATIONS

HIGH

|
---|---

LOW

|

| |

560m

| 78,000cd| 2m|

IPX8

|

(L)149.5(D)39mm (L)5.89 (D)1.54in

|

255g/ 8.99oz (Including Battery and Warrior Ring

All above specifications are test results based on ANSI/NEMA FL1-2009 Standard. The tests are performed using the battery included in the flashlight.
The tests are performed indoors under a room temperature of 25 degrees Celsius with windless conditions. The runtime may vary depending on the external temperature and ventilation conditions, and these biases may affect the results of testing.
Note: The maximum output brightness will decrease as the battery voltage decreases.

USB MAGNETIC CHARGING CABLE — MCC3

flashlight
Time to fully charge| 5.5 hours

PRODUCT OVERVIEW

AVAILABLE BATTERY

• 1 x customized 5000mAh 21700 rechargeable lithium-ion battery

BATTERY INSTALLATION

Before first use, unscrew the tailcup and remove the insulating film within the battery compartment before screwing the tailcup back on tightly. If the battery needs to be changed, make sure that the positive end of the new battery faces the flashlight head when you put it in.

CHARGING

Vibrating Power Indicator

It helps to alert if the battery is low (power≤20% vibrate once every 5 minutes; power≤10% vibrate once per minute; power≤5% vibrate once every 10 seconds).

• Before first use please fully charge the product.
• Connect the USB end of the magnetic charging cable to an external USB power source, then attach the other end of the cable to the magnetic charging port of the light. It takes no more than 5.5 hours to fully charge the light. (For reference only. When the USB power source is insufficient to provide 5V 2A power capacity, the charging time will be longer.) The red indicator means charging, while the green indicator means charging completed (battery level＞95%).
• Only charge with standard MCC3, not compatible with other MCC

TGR (TACTICAL GRIP RING) INSTALLATION

a. Unscrew the tailcup and remove the Warrior Ring.

b. Install the silicone TGR and tighten the tailcup.

DANGER

• DO NOT shine the light directly into human eyes. This may cause temporary blindness, or permanent damage to the eyes.
• DO NOT cover the flashlight’s head or place the head on the ground when the flashlight is on. The radiation energy may cause damage to the flashlight itself, or even result in the burning of flammable objects nearby.
• DO NOT use non-protected rechargeable batteries.
• DO NOT use the battery if the casing is broken.
• DO NOT take the battery out of the flashlight for charging.

WARNING

• Keep out of reach of children.
• DO NOT activate high mode repeatedly under high temperature to prevent the flashlight body from overheating and hurting the user’s hand.
• The tail switch may not work while immersed in sea water or other conductive media. Please try to keep it clean and dry.
• If the product is left unused or carried and transported, please loosen the tailcap a half turn to avoid accidentally activating the flashlight.
• Store the battery with care. If the battery needs to be changed, please take good care of the battery taken out. DO NOT mix it with the conductive metals.

NOTICE

• DO NOT short-circuit the tail switch cap with the surrounding ring. A short circuit in this case will result in a weak electric discharge between them and may lead to a complete battery drain if it is in this state for too long.
• The magnetic tail switch cap is easy to attract iron debris. Please keep the tail switch cap and the ring surrounding it clean

EXCLUSION CLAUSE

Olight is not liable for damages or injuries sustained resulting from the usage of the product inconsistent with the warnings in the manual.

HOW TO OPERATE

Click the tail switch lightly to produce a low light output or press the tail switch hard to produce a high light output.

Single click (click and release quickly) the tail switch to turn the flashlight on or off.

When you press and hold the switch, the flashlight will be in momentary mode; when you release the tail switch, it will turn off.

EU-DECLAATION OF CONFORMITY

EU-Declaration of Conformity can be found here: https://olightworld.com/ec- declaration

WARRANTY

Within 30 days of purchase: Contact the original seller for repair or replacement.
Within 5 years   of purchase: Contact Olight for repair or replacement.
Battery Warranty: Olight offers a one year warranty for all rechargeable batteries.

MBCC Magnetic UBSB Charging Cable: One year.

The other no warranty fragile or low-value fittings like lanyard and clip, you can contact post-sale in 30 days after purchase if it has quality drawback or damage under normal use condition. Over 30 days or damage under abnormal use condition, the conditional quality assurance will be provided as appropriate.

USA Customer Support
cs@olightstore.com
Global Customer Support
customer-service@olightworld.com

Visit www.olightworld.com to see our complete product line of portable illumination tools.

Dongguan Olite E-Commerce Technology Co., Ltd
4th Floor, Building 4, Kagu Industrial Park, No 6 Zhong nan Road, Chandan
Town, Dongguan City, Guangdong, China.
Made in China

References

• Olight | Illuminate Your World.
• Flashlights, Tactical Light, Outdoor Tools - Olight Official Store- Olight

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>