Schneider Electric MTN6260-7770 SpaceLogic KNX Touch IP 7 White Instructions

: June 9, 2024
: Schneider Electric

Table of Contents

Schneider Electric MTN6260-7770 SpaceLogic KNX Touch IP 7 White
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Schneider Electric MTN6260-7770 SpaceLogic KNX Touch IP 7 White

Instructions

MTN6260-7770 SpaceLogic KNX Touch IP 7 White
MTN6260-7760 SpaceLogic KNX Touch IP 7 Black

Illustration 1 and 2

Illustration 4 and 5

SpaceLogic KNX Touch IP 7

About this product

The SpaceLogic KNX Touch IP 7 Inch is a 7 inch touch screen with a horizontal or vertical orientation. The touch panel offers a wide range of functions. The touch panel is equipped with embedded application making configuration easy and fast.

The solution is designed to work closely with Wiser for KNX and spaceLYnk logic controllers.

Operating elements
A Reset button
B Touch screen
C Connection terminal
Dimensional drawings
Refer to the illustration for dimensions of the screen for appropriate mounting.
Install the product

HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
Safe electrical installation must be carried out only by skilled professionals. Skilled professionals must prove profound knowledge in the following areas:
- Connecting to installation networks.
- Connecting several electrical devices.
- Laying electric cables.
- Safety standards, local wiring rules and regulations.
  Failure to follow these instructions will result in death or serious injury.

Set the touch panel orientation

The mounting plates of the hooks are pre-mounted for horizontal orientation of the touch panel. If you want to mount the touch panel vertically, adjust the orientation of the mounting plates.

Remove all 4 mounting plates.
Rotate and screw the mounting plates back on.

Attaching the support plate to the wall

When attaching the support plate to the wall, the position and number of screws depend on the orientation of the touch panel.

The support plate can either be mounted on a size 60 installation box or directly on the wall.

Installation on a size 60 installation box

a. Horizontal orientation
b. Vertical orientation

Screw the appropriate supporting plate on a size 60 installation box using 2 screws according to the desired orientation.
Screw the supporting plate to the wall with the remaining screws.

Installation on the wall

Screw the appropriate supporting plate to the wall with 4 screws (horizontal alignment) or 3 screws (vertical alignment) according to the desired orientation.

Location

When choosing the installation location, the maximum cable length must be observed. The following shows the lengths from the touch panel to the respective assemblies in the system.

YR 2×0.8 mm, J-Y(ST)Y 2x2x0.8 mm, A-2Y(L)2Y 2x2x0.8 mm: cable must not be longer than 120m. A-2Y(L)2Y 2x2x0.6 mm, J-Y(ST)Y 2x2x0.6 mm: cable must not be longer than 80m.

Mounting

Perform connection according to the illustration shown in (C).
Insert the touch panel on the base plate (d).

Pin assignment

Follow the illustration to assign pins accurately.

Reading the full device guide online

Scan the QR code and choose your language for complete information about the device, including operation, configuration and using the product.

Technical data

Technical data continued 1

Trademarks

Android™ and Google Chrome™ are trademarks or registered trademarks of Google Inc.
Wi-Fi® is a registered trademark of the Wi-Fi Alliance.

EU Declaration of Conformity

Hereby, Schneider Electric Industries, declares that this product is in compliance with the essential requirements and other relevant provisions of RADIO EQUIPMENT DIRECTIVE 2014/53/EU. Declaration of conformity can be downloaded on: se.com/docs.