RETLUX RTL 205 LCD Televisions Electrical Household User Manual
- June 9, 2024
- RETLUX
Table of Contents
RETLUX RTL 205 LCD Televisions Electrical Household
PRODUCT DESCRIPTION
Thank you tor buying a RETLUX product. The RIL 205 lamp is an intelligent
product. Simply designed, it emits great light with an optional light colour.
In addition,
the product is equipped with an integrated night light in the foot of the
lamp.
SAFETY INSTRUCTIONS
Pay attention to warning note when putting the product into operation to avoid damage to health or property. The product is not a toy intended for children Only clean with a damp dloth dipped in water, do not use any detergents or solvents. Cleaning and maintenance must not be performed by children. The lamp is only suitable for indoor use. Before carrying out any work on the lamp or carrying out maintenance and service, the device must be disconnected from the power Supply! Ihe LED SOurce in the lamp Is not replaceable. Do not interfere With the product’s internal connections. In the event of damage to any part of the device, discontinue it s use immediately. The lamp is equipped with a non- replaceable by the user 2000 mAh Li-lon battery. Use any power adapter with an output voltage of 5 V and a USB type A connector to charge the lamp. The output current of the adapter may only be in the range of 1000-2500 mAh. (Power cable is included) Lamp, UsB power cable, operating manual
PACKAGE CONTENT START-UP
Remove the lamp trom its packaging and place it on a flat surface. Charge the
lamp Tuly berore using it Ttor the nrst time. Plug the included power cable
with the micro USB connector into the connector on the back of the lamp and
plug the other end of the cable into a USB power adapter (not included). When
the power is connected to the lamp, the charging process starts automatically.
The lamp foot will signal to charge with a dim red backlight. Once the
backlight turns dim green, the charging process is complete. You can
disconnect the lamp from charging. However, the lamp can be permanently
connected to the charging adapter. Turn the lamp on by repeatedly tapping the
symbol b ,and repeatedly tap on the same place to select cold white light
instead of a warm white. lap again to turn off the lamp. When you hold your
finger on the symbol a the lamp starts dimming. By holding on in the same spot
continually, the lamp will gradually light up. Stop holding when you will be
happy with the intensity of the light. Ihe last selected intensity 1S is
retained even after the lamp is turned off. The lamp has available ambient
night light c – the control button is located down in the foot of the lampc
.Press the button once to select the blended Colours (RGB mode) and then press
the same button to select the white ambient light. Press the C button again to
turn off the night light. If we bend the diffuser towards the foot of the
lamp, the lamp will turn off automatically. When the diffuser is raised again
to the horizontal position, the
the lamp turns on dry dill.
TECHNICAL SPECIFICATIONS
- Power USB DC 5 V, 1.0-2.5 A
- Battery 2000 mAh Li-ion (not replaceable by the
- Luminous lux user) 130 lm
- Power consumption 5 W
- Operating time per charge >3.5 h
- Charging time 4~5 h
- Optimal operating conditions Temperature: 0 to +40 °C; relative humidity: 10–60 %
WARRANTY LIMITATIONS
The technical information, installation, operation, and maintenance information and instructions in this manual correspond to the latest state before the manual was printed. Ihe manufacturer/importer does not assume responsibility for damages that may result from failure to follow instructions in the manual, unprofessional repairs and unauthorized changes. Changes to text, design, and technical specifications may occur without prior notice. Ihe waanty excludes damages incurred by improper use, mechanical damage, falls, repainting, and inexpert cleaning.
USED SYMBOLS
Designed for indoor use. Use only indoors. IP20
CE
The product meets EU requirements. The product is classified as an electrical
appliance subject to the Directive on electrical and electronic equipment
waste. Do not dispose of it in municipal waste. Text, design, and parameters
are subject to change without notice. Manufacturer Address: RETLUX – FAST CR,
a. s, U Sanitasu 1621, 251 01 Ričany, Czech Republic The original version is
in Czech.