Superior Life PQL-55353 LED V2 Wrap A-Round Instruction Manual

: June 4, 2024
: Superior Life

Table of Contents

INSTALLATION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LED V2 WRAP A-ROUND
INSTALL INSTRUCTIONS

PLEASE FIND A QUALIFIED ELECTRICIAN FOR INSTALLATION. Please read the instructions before you install and use the luminaire.
WARNING, CAUTIONS, AND OPERATING INSTRUCTIONS

To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions, and other hazards read all warnings and instructions included with and on the fixture box and all fixture labels.
Before installing, servicing, or performing routine maintenance on this equipment, follow these general precautions.
Commercial installation, service, and maintenance of luminaires should be performed by a qualified licensed electrician.
For the installation: If you are unsure about the installation or maintenance of the luminaires, consult a qualified licensed electrician and check your local electrical code.
To prevent wiring damage or abrasion, do not expose wiring to the edges of sheet metal or other sharp objects.
Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.

WARNING: RISK OF FIRE OR ELECTRICAL SHOCK

Turn off electrical power at the fuse or circuit breaker box before wiring the fixture to the power supply.
Turn off the power when you perform any maintenance.
Verify that the supply voltage is correct by comparing it with the luminaire label information.
All wiring connections should be capped with UL-approved wire connectors.

CAUTION: RISK OF INJURY

If the lens is removed, avoid looking directly at the light source while it is on.
Account for small parts and destroy packing material, as these may be hazardous to children.
Risk of burn. Disconnect power and allow the fixture to cool before handing the fixture.
Green ground screw provided in the proper location. DO NOT RELOCATE.
Minimum 90° supply conductors.
Suitable for Dry or Damp locations.

WARNING DISCONNECT POWER BEFORE INSTALLING OR SERVICING.

INSTALLATION

Remove the fixture from the packaging.
Remove the lens by pulling over the lip on one side of the fixture and rotating on the other side; lift the lens off.
For mounting, use the mounting holes on each end of the fixture housing. Mount per required application:
Surface or Suspended
• SURFACE: Secure the fixture to the mounting surface.
• CHAIN MOUNTING WITH V-HOOK (Sold Separately):
Attach customer-supplied V-hooks to fixture.
Attach the customer-supplied chain to the V-hooks and mounting surface
• CABLE MOUNTING (Sold Separately): Mount customer-supplied cable to the luminaire. Wrap one end of the cable to the beam, then insert it into the hasp, and adjust the cable to the desired height.
Make electrical connections according to the General Wiring Diagram and local electrical codes.
Install junction box cover.
Install the lens on one side of the fixture and push up to engage the opposite side. Make sure the lens has seated securely over fixture lips by gently pulling down along both sides.