Mircom FleX-Net FX-4000 Network Fire Alarm Control Panel User Guide
- June 9, 2024
- Mircom
Table of Contents
Mircom FleX-Net FX-4000 Network Fire Alarm Control Panel
Factory Default Jumper Settings
To ensure the correct operation of the Fire Alarm Control Panel, check that the jumpers on the main board are set correctly.
| Jumper | Factory Default | Notes |
|---|---|---|
| JW1 | Closed | Open this jumper if a PR-300 or UDACT-300 is installed |
| JW2 | Open | Do not change |
| JW3 | Closed on pins 1 and 2 |
(2 leftmost pins)
| Do not change
JW4| Closed| Do not change
JW5| Open| Close this jumper to silence the on-board buzzer
P12| Closed on pins 1 and 2
(2 rightmost pins)
| Do not change
Terminal| Factory Default| Notes
TS2
| There is a wire connecting positions E+ and I+
(the 2 top pins)
| Do not remove
For more details, see LT-894MP the FleX-Net™ FX-4000 Installation Manual.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>