sudio F2 Portable Bluetooth Speaker Owner’s Manual
- June 9, 2024
- Sudio
Table of Contents
sudio F2 Portable Bluetooth Speaker
Broadcast function
- Turn on both F2 speakers by holding 2 sec
- Hold (O)2 sec on the first F2
- Hold ( button 2 sec on other F2 to link
- End broadcast by pressing ( button lx
Charging
Use USB-C to charge. Amber and white flashing light charging. White light charged.
Factory reset
- Hold ()2 seconds to turn F2 on.
- Hold ) button 10 seconds, the LED will turn off
Included in the box
- F2
- Charging cable
- Warnings folder
- Owners Manual
Pairing to a device
- Hold ()2 seconds to turn F2 on
- Lights will blink white/amber, connect to device
- Hold (D) 2 sec to disconnect, F2 will go into pairing mode
EN Playback operations
- Play and pause Ix click
- Volume up lx click
- Volume down Ix click
- Next track 2x clicks
- Previous track 2x clicks
Phone call operations
Accept calls: lx click on the (D) button Hang up or reject calls: Hold the button 2 seconds
Battery indication
The LED lights amber when battery is between 0-25%, and white when between 26%-100%
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or
modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference ina residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interterence to rddio
communications. However, there is no guarantee that interterence will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interterence by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirements in
portable exposure conditions without restriction.