DARCO 779566 Web Ankle Brace Instructions
- June 4, 2024
- DARCO
Table of Contents
DARCO 779566 Web Ankle Brace
Lift flaps from stay pockets located on each side of the ankle brace. Insert
the Lateral stay (Red sticker) into the outside pocket. Insert the Medial stay
(Blue sticker) into the inside pocket. The stays may be switched to
accommodate a left or right ankle. Re-insert the flaps over the stays to
secure them in place. Note: If less rigidity is required this step can be
skipped or the stays can be removed at a later time.
- Lateral – Outside Stay
- Medial – Inside Stay
Open up the back of the brace, slide your foot into the brace and secure hook
and loop fastener backing evenly.
Grasp the lower straps and adjust for equal length. Stretch the straps and
wrap them around your ankle, securing them in the back.
Cross the upper strap over the center and wrap around the top of ankle to
secure.
The bungee closure system can be easily adjusted without removing your shoe. Simply tighten and adjust the straps as needed to ensure consistent compression and a snug fit.
An adhesive backed foam spacer is included with the brace. The spacer can be trimmed and placed on the rigid stays if more padding is needed for comfort.
Cleaning Instructions
- • REMOVE RIGID STAYS BEFORE WASHING.
- • The Web™ Ankle Brace is machine washable using a mild detergent and warm water.
- • To prevent the hook and loop fastener straps from damaging other items in the wash, place the Web™ in the included mesh bag before washing or wash separately.
- • Remove promptly and air dry.
CAUTION: Do not over tighten – this could lead to decreased circulation. If you experience pain, abnormal swelling, or skin irritation, discontinue use and contact your medical provider.
MADE IN CHINA
810 Memorial Blvd. | Huntington, WV 25701 | USA
800-999-8866 |
[email protected]
This product contains no latex.