LIGHEART CR22081A Remote Control User Manual
- June 9, 2024
- LIGHEART
Table of Contents
LIGHEART CR22081A Remote Control
Remote Control
Directions For Use
-
How to pair all lights:
Press the “ ” button within 5 seconds after turning on all lights at the same time, until the lights flash. When the pair have done, short press the “ ” or “ ” button to turn on/off all lights. -
How to independently pair No.1 and No.2 lights:
Pair No.1 light:
Firstly, turn off the knob switch on the base plate of the No.2 light Secondly, press the “ ” button within 5 seconds after turning on the No.1 light, until the light flashes. Default pair to” ” button. When the pair have done, short press the “ ” button to turn on/off the No.1 light.
Pair No.2 light:
Firstly, turn off the knob switch on the base plate of the No.1 light Secondly, press the “ ” button within 5 seconds after turning on the No.2 light, until the light flashes. When the pair did, short press the” ” button to turn on/off the No.2 light.
Please Note: Before independently pairing the light, you need to turn off the knob switch on the base plate of other lights, otherwise it may pair fail. -
How to adjust the color and brightness alone of No.1 and No.2 lights:
- Step 1: Independently pair No.1 and No.2 lights.
- Step 2: Turn off the No.2 light and then adjust the color and brightness of the No.1 light.
- Step 3: Turn off the No.1 light and then adjust the color and brightness of the No.2 light.
- Please Note: Before adjusting the color and brightness of the light, you need to turn off the knob switch on the base plate of other lights, otherwise it may adjust fail.
-
How to clear pair remote control:
Long press the “ ” button within 5 seconds after turning on all lights, until the lights flash.
FCC WARNING STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.