Splash Design XZL20-11 Bluetooth temperature controller User Manual
- June 5, 2024
- Splash Design
Table of Contents
User Manual
Bluetooth switch controller operation manual
Product photographs：
Functional
- Red and blue indicate the Bluetooth status, the red light is shining, the Bluetooth is in the waiting state when the table is connected, and when the connection is successful, the blue light will always be on.
- On/off machine and function gear operation control
- Four color lights indicate the appropriate gear
- Three lights in two colors (blue and red) and three states (normally bright and shiny, Undervoltage water flashing) indicate the real-time electric quantity
Two, operation instructions：
-
POST
The power on display lamp shows the current power and will automatically turn off after 3 seconds. (Three blue lights show electric quantity) -
Boot
| Long press the button for about 1.3 seconds to start the machine, and the
current battery will be displayed after starting the machine 4 workings, 100%
output, red gear,
---|---
| Press the button again lightly, 3 gear, 80% output, the gear display purple,
bright purple light
| Press the button again lightly, 2 gear, 60% output, gear display blue,
bright blue light
| Press the key again lightly, 1 gear, 40% output, gear display white, bright
white light
| Press the button again, and then rotate to 4-3-2-1.
note：
- When it is detected that the input voltage is lower than 5.5V or the high voltage is 16V (±0.5V), the controller’s electric quantity shows the flashing water with no output and no operation
- When the power is less than 10%, it will automatically switch to 1 and output 40%/ 30%. You can also manually switch to another gear
- The gear has a memory to remember the state of the last shutdown. For example, when the blue light is turned off, the working state of the blue light’s gear will be displayed when the next power is on.
- power off
Long press the button for about 1.3 seconds to turn it off. When it is turned off, the current power level will be displayed automatically, and it will turn off automatically after about 3 seconds.
Three, power display：
When the real-time power is 100%, the 3 blue lights are on.
When the real-time 60% power indicator light 2 blue lights on,
When the real-time 30% power indicator 1 blue light is on,
When the real-time power 10% power indicator 1 red light on
When the real-time power is less than 10%, the power indicator, red light has
been flashing on
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>