SMART AIR SA-600 Air Purifier User Manual
- June 9, 2024
- SMART AIR
Table of Contents
SA-600 Air Purifier
Simple, no-nonsense clean air
User Manual
SA-600 Air Purifier
READ AND SAVE THESE INSTRUCTIONS
(Stuff Our Lawyers Made Us Say)
WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
- Read all instructions before using appliance.
- Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer.
- To protect against electrical hazards, DO NOT immerse it in the water or other liquids. Do not use near wet area.
- Always unplug the air purifier before moving it. Change filters or clean the air purifier when it is not in use. Be sure to pull by the plug and not the cord.
- NEVER drop or insert any object into any openings of this unit.
- DO NOT run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
- DO NOT operate any appliance with a damaged cord or plug. Discard fan or return to an authorized service facility for examination and/or repair
- Use appliance only for intended household use as described in this manual. Any other use not recommended by the manufacturer may cause fie, electric shock or injury to persons.
- DO NOT place anything on top of unit.
- DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void your warranty. The inside of the unit contains no user serviceable parts. All servicing should be performed by qualified personnel only.
Correct Disposal of this product
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for
environmental safe recycling.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
This appliance can be used by children aged from 8 years and above under
supervision. This appliance can be used by persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in
a safe way and understand the hazards involved. Children shall not play with
the appliance.
Cleaning and user maintenance shall not be made by children without
supervision.
Refined & Reliable Clean Air
When designing the SA-600, we wanted to make an air purifier that can reliably
keep large spaces like classrooms, offices and living rooms safe and clean.
The SA-600 doubles up on filters to provide more clean air at lower noise
levels. Refined through Smart Air’s almost 10 years of research and
experience, the SA-600 is our most cost-effective purifier yet.
Features
- Dual-inlet design for more clean air
- Double the filters, improving effectiveness while lowering cost
- Low noise design
- ‘Do Not Disturb’ mode for silent, distraction-free operation
- Child lock to keep your SA-600 operating and prevents any purifier settings from being changed
- Pre-filter, HEPA and carbon filters for all-round protection
About Smart Air
Smart Air is a social enterprise and certified B-corp dedicated to
distributing cost-effective air purifiers and providing open-source data and
science to combat the harms of air pollution.
Getting To Know Your SA-600
Front View
Control Panel View
Turning On Your SA-600
Follow these steps to start breathing cool, clean air with your SA-600:
Step 1: Remove SA-600 from the box.
Step 2: Place your SA-600 on a firm, level and flat floor & plug the
supplied power cord into an AC outlet.
- For proper air flow, ensure the inlets (front and back) are located at least 30cm (1 ft) from any wall or item of furniture.
- Air enters the air purifier from the front and back, make sure neither side is blocked.
Step 3: Press the Power On/Off button on the control panel to turn on.
The indicator lights on the buttons will light up once connected to power the first time. The SA-600 defaults to a fan speed of ‘Low’.
‘Do Not Disturb’ Mode
To save energy and reduce the impact of the SA-600’s lights on your
environment, the SA-600 includes a built-in, automatic ‘Do Not Disturb’ mode.
If the SA-600’s buttons are not touched for 3 minutes, all control lights will
turn off. The next time you touch any button on the SA-600, the lights will
turn back on, showing you the previous purifier state. This mode will not work
when your filter needs replacing.
‘Child Lock’ Mode
The ‘Child Lock’ mode locks the current purifier state and prevents any
purifier settings from being changed.
To enter ‘Child Lock’ mode, simply hold the ‘Child Lock’ button for 3 seconds.
The ‘Child Lock’ light will then illuminate. In this mode, pressing any button
will not alter the purifier’s state. Pressing a button will cause the ‘Child
Lock’ light to flash continuously.
To exit ‘Child Lock’ mode, hold the button for 3 seconds and the light will
stop flashing.
Cleaning & Maintaining Your SA-600
The SA-600 should be cleaned at least once every month using a dry and clean
cloth. Depending on the environmental conditions, more frequent cleaning may
be required.
Product Information
Product No.: SA-600
Dimensions: 350mm x 232mm x 510 mm
Recommended Coverage Area: ≤55㎡
Power: 60W
Voltage: 100-240V~ / 50-60Hz
Noise (high): 53 dB
Material: ABS Plastic
Net Weight: 6.9 kg
SA-600 + H13 HEPA + Carbon CADR : 470 m³/hr
Airflow: 480 m³/hr SA-600 + H13 HEPA
CADR: 500 m³/hr
Airflow: 505 m³/hr
Replacing The HEPA Filter
- The filter reset indicator will flash continuously when your filter needs replacing:
- Pull out the front cover then lift out the Pre-filter, HEPA and/or Carbon filter.
- Remove your new HEPA filter from its bag.
- Insert your new HEPA/Carbon filter. Ensure the arrow on the filter is in the correct direction outwards.
- After inserting the front cover back into your purifier, hold the filter replacement indicator for 4 s. This resets the filter replacement indicator. The filter replacement indicator will stop flashing once it has been reset.
Note: the filter indicator light will illuminate after your fan purifier
has been running for approximately 1045 hours.
For more information on how this number varies based on your usage, visit:
https://smartairfilters.com/SA600-replacement
Read this manual in your language: scan the QR code!
https://smartairfilters.com/sqair/manuals
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>