YM6505 SATELLINE-EASy High Performance UHF Radio Modem User Guide
- June 9, 2024
- Satel
Table of Contents
YM6505 SATELLINE-EASy High Performance UHF Radio Modem
Testing a modem pair with SATEL Test-Kit
Equipment needed
- Computer with two COM ports
- SATELLINE SaTerm 5 software
- 2 pcs YC0210 NARS-1F-4A-SC (interface adapter)
- 2 pcs YC0201 CRS-9 serial cable (extension cable for NARS-1F)
- 2 pcs YP0115 A-AC (power supply, 100-240 Vac / 15 Vdc / 4.6 A)
- 2 pcs YC0904 C-M (mains cable, European plug)
- 2 pcs YA0800 ATT-1 (coaxial attenuator, 65 dB, 2 W max. RF input, TNC connectors)
- 1 pc YC1150 CRF-50 (coaxial cable, 50 cm, TNC connectors)
- Connect the RS cables to COM ports.
- Connect the power cables to A-AC power supply.
- Connect the attenuators ATT-1 to modems’ antenna connectors and attenuators together by CRF-50 antenna cable.
- Open the SaTerm 5 software by click SaTerm icon:
SATELLINE SaTerm settings to transmitting modem (COM 1)
Click Mode and Open terminal.
- Set correct com port number (first free com port, usually COM1).
- Set port parameters equally between SaTerm and radio modem (port rate, parity, data and stop bits). View = ASCII. Handshake = None.
Click Mode and Transmit to open transmit window:
- Write to text box example “Modem test line”.
- Settings: data form=text, counter=on, continuous=on, put cf/lf to end=on, delay=1sek.
SATELLINE SaTerm settings to receiving modem (COM 2)
Click Mode and Open terminal
- Set correct com port number (first free com port, usually COM2)
- Set correct baud rate, parity, data bits, stop bit, view=ASCII
TESTING DATA MODEM 1 TO MODEM 2
- Click SEND in transmit window.
- Control at window COM2 that all characters are correct.
- Stop testing by click CANCEL.
TESTING DATA MODEM 2 TO MODEM 1
- Switch modems opposite and test in the same way.
- ADDRESS: SATEL Oy P.O.Box 142, FI-24101 SALO FINLAND
- Tel: +358 2 777 7800
- www.satel.com
- info@satel.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>