muRata Type 2EG LBCA1HN2EG Bluetooth Module User Manual
- June 9, 2024
- muRata
Table of Contents
muRata Type 2EG LBCA1HN2EG Bluetooth Module
Revision History
INTRODUCTION
Scope This document provides the setup instructions for the Murata Type2EG BLE Evaluation Kit (EVK).
Audience
This document is intended for software/fimware, hardware and systems engineers
to evaluate and develop applications with Murata’s Type2EG BLE module.
Kit Contents
The Murata Type2EG EVK package contains the following items:
- TypezEG evaluation board
- 1USB cable
DESCRIPTION
The EVK is an evaluation and application development kit for the Murata
Type2EG BLE module. It mainly includes a Murata Type2EG module and a
programming chip. It is similar to OnSemi’s RSL15 evaluation board (EVB).
Note: All the evaluation and test procedures on the original RSL15 EVB
can be used on the ypezEG EVK.
The only dirference rom the kSL15 EVBIs the way of doing conducted test. Ihe
tollow table and picture show the components tor antenna configuration. Modity
the board using the Onboard antenna” ine in below table to select the onboard
antenna, or “uFL connector” line for RF conducted test.
Power up
The initial software flashed on the module may be the blinky sample application, which may behave as below.
- Connect the USB cable to a PC or insert a BR2032 (or CR2032) battery
- The LEDs will blink rapidly
- Press the SW1 button, the LEDs will stop blinking
- Press the SW1 button again, the LEDs will restart blinking
Evaluation
To do other evaluation or tests, follow OnSemi’s documentation. The RSL15 EVB’s user manual (including power consumption measurement, schematics, etc.) can be found at OnSemi’s portal: https://www.onsemi.com/design/tools-software /evaluation-board/rsl15-evb. More product info (documentation package, software development IDE, RF tools, etc.) can be found at: https://www.onsemi.com/rsl15.