hama 00186358 TH-100 LCD Thermometer/Hygrometer User Manual

hama 00186358 TH-100 LCD Thermometer/Hygrometer

Operating instruction

Controls and Displays

1. Display
2. Moon phase display
3. MODE button
4. ADJUST button
5. SET button
6. SNOOZE button
7. Battery compartment
8. Measurement opening (do not cover)

Explanation of Warning Symbols and Notes

• Warning
  This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.

• Note
  This symbol is used to indicate additional information or important notes.

Package Contents

• TH-100 LCD thermometer/hygrometer
• 1 LR1130 button cell battery
• These operating instructions

Safety Notes

• The product is intended for private, non-commercial use only.
• Protect the product from dirt, moisture and overheating, and only use it in a dry environment.
• Do not use the product in the immediate vicinity of heaters or other heat sources or in direct sunlight.
• Do not operate the product outside the power limits given in the specifications.
• Do not drop the product and do not expose it to any major shocks.
• Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
• Do not modify the product in any way. Doing so voids the warranty.
• Use the product for its intended purpose only.
• Do not use the product in areas where the use of electronic devices is not permitted.
• Keep the packaging material out of the reach of children due to the risk of suffocation.
• Dispose of packaging material immediately according to locally applicable regulations.
• Do not open the device or continue to operate it if it becomes damaged.
• Keep this product, as all electrical products, out of the reach of children!
• Use the item only in moderate climatic conditions

Warning – Batteries

• When inserting batteries, note the correct polarity (+ and – markings) and insert the batteries accordingly. Failure to do so could result in the batteries leaking or exploding.
• Only use batteries (or rechargeable batteries) that match the specified type.
• Before you insert the batteries, clean the battery contacts and the polar contacts.
• Do not allow children to change batteries without supervision.
• Do not mix old and new batteries or batteries of a different type or make.
• Remove the batteries from products that are not being used for an extended period (unless these are being kept ready for an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not throw batteries in a fire.
• Keep batteries out of the reach of children.
• Never open, damage or swallow batteries or allow them to enter the environment.

They can contain toxic, environmentally harmful heavy metals.

Warning – Batteries

• Immediately remove and dispose of dead batteries from the product.
• Avoid storing, charging or using the device in extreme temperatures and extremely low atmospheric pressure (for example, at high altitudes).

Warning – Button cells

• Do not ingest battery, risk of burns due to dangerous substances.
• This product contains button cells. If swallowed, the button cell can cause severe internal burns within just two hours and lead to death.
• Keep new and used batteries out of the reach of children.
• If the battery compartment does not close securely, stop using the product and keep it out of the reach of children.
• If you think that batteries were swallowed or are in a part of the body, seek medical assistance immediately

Getting Started

Inserting the battery

Open the battery compartment (7), remove the contact breaker and then close the battery compartment (7). The thermometer is now ready for use

Replacing the batteries

• If the display (1) becomes dimmer, you must replace the battery.
• When inserting the batteries, ensure that the polarity is correct (+ to the top, – to the bottom).

Operation

• Press the MODE button (3) to switch between the three display modes available. The modes are as follows (in that order): clock, alarm, calendar.

Note

• The product is usually in clock mode. If the product is in another mode, press the MODE button (3) until it is in the mode you want.
• When you adjust the settings, the selected item will flash to indicate that it can be set

Setting the time format/time

• In clock mode, press and hold the SET button (5) for about 2 seconds to start setting the time:
  • 12/24 hour format
  • Hours
  • Minutes
• Press the ADJUST button (4) to select the individual values.
• Press the SET button (5) to adopt the set value displayed and skip to the next item.
• Press the MODE button (3) to save the settings and return to the normal display.

Setting the alarm

• In alarm mode, press and hold the SET button (5) for about 2 seconds to start setting the alarm:
  • Hours
  • Minutes
• Press the ADJUST button (4) to select the individual values.
• Press the SET button (5) to adopt the set value displayed and skip to the next item.
• Press the MODE button (3) to save the settings and return to the normal display.

Setting the calendar

• In calendar mode, press and hold the SET button (5) for about 2 seconds to start setting the calendar:
  • Year
  • Month
  • Day
• Press the ADJUST button (4) to select the individual values.
• Press the SET button (5) to adopt the set value displayed and skip to the next item.
• Press the MODE button (3) to save the settings and return to the normal display.

Note

• The weekday is set automatically when setting the date manually.
• In the 12-hour format, PM (from noon to one minute before midnight) appears before the time.
• The settings that were made up to that point are not saved

Temperature measurements, maximum/minimum display

• In clock mode, press the SET button (5) to choose between °C (Celsius) and °F (Fahrenheit).
• Press the ADJUST button (4) to display the maximum or minimum values for temperature and humidity recording.
• Press the ADJUST button (4) for about 2 seconds to delete these recordings and start recording again.

Note
If the ambient humidity is less than 20%, LL is shown in the corresponding field on the display.

Alarm and hourly chime

• In alarm mode, press the ADJUST button to switch the alarms on or off. The bell symbol stands for the alarm and the propeller symbol stands for the clock hour.
  If one of these symbols appears on the display, the relevant functions are activated.

• If the alarm is switched on, it will stop going off automatically after about a minute or when the SNOOZE button (6) is pressed. If you press the SNOOZE button (6), the alarm will go off again four times.

Moon phase display (2)

• A: New moon
• B: Waxing crescent
• C: Half moon (first quarter)
• D: Waxing half moon
• E: Full moon
• F: Waning full moon
• G: Half moon (last quarter)
• H : Waning crescent

Care and Maintenance

Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning agents. Make sure that water does not get into the product.

Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.

Technical Data

Hama GmbH & Co KG 86652 Monheim / Germany

Service & Support
www.hama.com
+49 9091 502-0

All listed brands are trademarks of the corresponding companies. Errors and omissions excepted, and subject to technical changes. Our general terms of delivery and payment are applied

References

• hama.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>