FIAMMA 98655Z147 Kit Combi Rail Bracket Instruction Manual
- June 9, 2024
- FIAMMA
Table of Contents
FIAMMA 98655Z147 Kit Combi Rail Bracket Instruction
Installation instructions for brackets
Please consult the website for instructions in the languages: NL-SV-DA-NO-FI- PT
KIT COMBI RAIL BRACKET
Rail Brandrup – Vamoose 98655Z147
Package contents
Check that nothing has been damaged or deformed during transport.
In the event of doubts or questions concerning the installation, use or
limitations of the product, contact the dealer. We recommend that the
installation is carried out by qualifi ed personnel and in compliance with
current local regulations.
Installation instructions
ATTENTION: INSTALLATION ON FIXING KIT
-
The awnings are to be fi xed on the brackets so that the words “SUPPORT” on the awning are in correspondence of the brackets: this condition is necessary and indispensable for the two brackets situated at the extremities (which are located on the fi xing point of the arms on the case-box). It
is important, but not indispensable, for the central bracket/s as it/they provide/s only a mounting support. -
The brackets must always be well-aligned to each other to avoid later problems; in case they are not, they must be properly shimmed using the spacers to ensure the alignment.
-
The installation of the awning can occur only when the brackets are perfectly aligned to the roof of the vehicle.
Before tightening the screws, make sure that the awning position doesn’t
prevent the opening of the rear door.
Safety instructions
When using the awning please follow the instructions of the product.
ATTENTION Periodically check the brackets to make sure they are firmly attached (especially after the first kilometers) make sure the bolts are not loose and that holding brackets have not shifted.
Read the following instructions and warnings carefully; failure to observe
these installation and usage instructions as well as the laws for driving in
the relevant country may cause severe harm or damage for which the
manufacturer declines all responsibility.
Before installation, ensure compatibility with the vehicle on which the
product must be installed. Checking that the wall/roof/rear door is suffi
ciently solid and suitable for guaranteeing the resistance of the anchoring
points is always mandatory. If not, strength and compliance with the maximum
load indicated in the instructions are not guaranteed and it will be necessary
to reinforce it these points.
In the event of an accident involving the vehicle and/or the product, ensure
that the product has not been damaged. In the event of damage, contact your
local retailer before moving the vehicle. Fiamma declines every responsibility
for any modifi cation of the product that may cause damage and/or injury to
things and people.
Warranty Fiamma
In case of defects with regards to materials and manufacturing, the customer is entitled to the warranty in accordance with local laws and regulations of the country in which the product was purchased.fiamma.com
Fiamma S.p.A. – Italy
Via San Rocco, 56
21010 Cardano al Campo (VA)
All rights reserved.
Fiamma S.p.A.
reserves the right to modify at any time, without notice, prices, materials,
specifi cations and models or to cease production of any model.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>