Kawasaki 14475 Hard Coated Polycarbonate Windshield User Manual
- June 9, 2024
- Kawasaki
Table of Contents
14475 Hard Coated Polycarbonate Windshield
User Manual
EMP P/N – 14475
KAWASAKI MULE PRO-MX
Hard Coated Polycarbonate Windshield
Fits: 2019-2022 MULE® PRO-MX
14475 Hard Coated Polycarbonate Windshield
Includes:
- (1) 14475-01 Windshield
- (2) 13750-03 Slide Vents
Hardware Kit:
- (8) Rubber Fast Strap (11651)
- (4) 1/4” x 1-1/4” Fender Washer lack (used between vents and windshield as a spacer)
- (4) Female Thumbscrew, 1.72” Dia. (BR-F4-B-21)
- (4) 1/4-20 x 3/4” Carriage Bolt (must be 3/4”)
- (2) 3/16” x 48” Bubble Edge Trim (13623-TIM)
- (1) EMP® Logo Decal
Tools Needed:
- Phillips screw driver
- 7/16” Wrench
Installation should be performed by a certified technician.
NOTE: Once the protective film is removed this item can not be
returned. Check for fitment before removing film.
Installation:
- Peel back the film along the top, bottom and along the sides exposing the slots.
- Attach the rubber fast straps to the slots as shown. The big washer goes in the front. Do not fully tighten yet.
- Slide the bubble edge trim over the top and bottom.
- Remove the film from both sides of the slide vents and around the vent hole pattern in the windshield.
- Attach the slide vents using the carriage bolts, large washers and thumbscrews. The washers will go between the vent and the windshield. Insert the carriage bolt in from the front, then the washers, then the vent and finally the thumbscrews.
- Once assembled place on your Mule and fully tighten the hardware.
- Your installation is complete.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>