CHESHIRE mouldings WPKT4 MDF Wall Panel Instructions
- June 9, 2024
- CHESHIRE mouldings
Table of Contents
CHESHIRE mouldings WPKT4 MDF Wall Panel Instructions
Important Information
The following instructions are for installing the Cheshire Mouldings – MDF
Wall Kit (WPKT4). MDF Wall Kit has a coverage of approx. 1.2m².
If you have any queries please contact our technical helpline on 0800 085
3475.
Please note:
All components should be inspected BEFORE installation commences for any
damage, as Cheshire Mouldings cannot be held responsible for any damage caused
during installation.
We do not recommend the use of a sharp blade to open the packaging as this may
damage the product
Tools required:
Tape measure, pencil, adhesive, nail gun.
Kit contents
6x 1.2m MDF Strips (97mm x 9mm)
All products unfinished
MDF Wall Kit (WPKT4) Fitting Instructions
Measure up from top of skirting board to your preferred panelling height. Mark
position and draw horizontal line across.
Check with spirit level (Fig 1).
Measure length of wall. Mark and cut enough strips to run across top of
skirting and across horizontal line previously drawn.
Apply adhesive to backs of strips (Fig 2)
Offer strips into position and secure with nail gun (Fig 3).
To work out how many panels you require, measure wall length and subtract width of 1 panel strip. (Fig 4).
Example:
- Wall length = 2000mm
- Width of wall panel strip = 97mm
- 2000mm – 97mm = 1903mm
- Divide this dimension by how many panels you prefer. In this example we are using 3 panels
- 1903mm divided by 3 = 634mm centres
- The actual distance between panel strips will be 634mm minus width of 1 panel strip
- 634mm – 97mm = 537mm between strips
Measure distance between top and bottom strips and cut 4 vertical anel strips. Apply adhesive to back of strips. Offer 2 strips between horizontal strips , placing one of them at each end of the run. Secure with nail gun (Fig 5).
Measure distance between top and bottom strips and cut 4 vertical panel strips. Apply adhesive to back of strips. Offer 2 strips between horizontal strips , placing one of them at each end of the run. Secure with nail gun (Fig 5).
Offer remaining strips between horizontal strips and space them according to
figure worked out in Fig 4 ie 537mm between strips. Secure with nail gun (Fig
6).
Fill all gaps and joints with decorators caulk.
Wipe off any excess with damp cloth. Sand to a smooth finish. You are now
ready to paint
MDF Wall Kit (WPKT4) Fitting Instructions
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>