SONY RMF-TX500U Bravia Smart TV Remote Control User Manual
- June 9, 2024
- Sony
Table of Contents
SONY RMF-TX500U Bravia Smart TV Remote Control
PRODUCT DIAGRAM
How to Pair Bluetooth:
- Turn on the TV, install new batteries on the remote control and face the TV.
- Find the [ Setting ] on the TV menu, click to enter.
- Select [ Remote control & Accessories].
- Select [ Remote control] ( Note: Make sure the [ Bluetooth] option is tuned on].
- Select [ Connect via Bluetooth l
- The system will prompt:
Are you sure you want to connect a new remote control ?
Select [ Connect a new Remote]
- Press and hold the volume- button, then press and hold the voice button for 3 seconds and then release both button.
Connecting …
Now the new remote has been connected
FCC Warning
- This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
- This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference,
- this device must accept any interference received, including interference that may cause undesired operation.
- This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0cm between the radiator and your body.
Read User Manual Online (PDF format)
Loading......