Govee H6150 White LED Strip Lights User Manual
- June 4, 2024
- Govee
Table of Contents
Govee H6150 White LED Strip Lights
What You Get
- Strip Lights 1
- Power Adapter 1
- User Manual 1
- Service Card 1
Specifications
- Length 5m/16.4ft
- Lighting Color White
- Waterproof No
- Control Method Control box
- Power Supply 12VAdapter
Installing Your Strip Lights
Preparation Before Installing
- Installing Your Strip Lights
- Preparation Before Installing
Preparation Before Installing
- Wipe the surface to make sure it’s clean and dry.
- b.Peel off the protective film on the tape, stick the strip on and press over it firmly.
- Reinforce via clips around corners.
- Peel off the protective film on the control box and stick it on.
- Power on the strip lights and start using.
Troubleshooting
-
The strip light flickers or the light is not bright enough.
Plug out the adapter port and re-plug it in. -
The adhesive tape is not strong enough.
-
Make sure the installation surface is clean and dry.
- Firmly press over the strip after sticking.
- Reinforce the installation via more clips and tape.
-
The control box doesn’t work.
Re-plug in the adapter port and try again. -
The strip lights don’t work.
- Pull out every connective part of the strip lights and firmly re-connect them.
- Tap On/Off button on the control box or app to check whether it is a strip quality issue.
Customer Service
- Warranty: 12-Month Limited Warranty
- Support: Lifetime Technical Support
- Email: support@govee.com
- Official Website: www.govee.com
- @Govee r::J @Govee CJ @Govee ll!D @Goveeofficial
Compliance Information
EU Compliance Statement:
Shenzhen Intellirocks Tech Co. Ltd. hereby declares that this device is in
compliance with the essential requirements and other relevant provisions of
the Directive 2014/30/EU. A copy of the EU Declaration of Conformity is
available online at www.govee.com/
EU contact address:
EC REP eldcocool mbH (E-mail: info@bellacocool.de)
ECREPPettenkoferstraße 18, 10247 Berlin, Germany
FCC Statement
This device complies with Part 15 of the FCC Rules.Operation is
Subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Non-replaceable light source.
- Do not connect the rope l packing or wound onto a reel;
- Do not use the rope light when covered or recessed into a surface;
- Do not open or cut the rope light; ght to the supply while it is in the
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>