CAFE CIP36NP2VS1 Fully Integrated French Door Bottom Freezer Owner’s Manual

CAFE CIP36NP2VS1 Fully Integrated French Door Bottom Freezer

WARRANTY

Labor Warranty| Limited 1-year entire appliance
Limited 5-year sealed refrigerating system
---|---
Parts Warranty| Limited 1-year entire appliance
Limited 5-year sealed refrigerating system

FEATURES & BENEFITS

frozen items
Refrigerant type| r600a
Sealed system design| Yes
Defrost type| Automatic defrost
Connected| Connect Plus WiFi; App details; Display/change temperature; Alert if fresh food temperature is too high; Alert if freezer temperature is too high; Alert if water filter needs to be placed; Alert for software OTA updates

WEIGHTS & DIMENSIONS

ADDITIONAL ACCESSORIES

• CXSB4H4PVBZ Brushed Bronze Optional Kits

• CXSB4H4PVBT Brushed Black Optional Kits

• CXSB4H4PVCU Brushed Copper Optional Kits

• CXSB4H4PVCG Brushed Brass Optional Kits

• CXSB4H4PVFB Flat Black Optional Kits

DIMENSIONS AND INSTALLATION

Power / Ratings

Volts/Hertz/Amps 115V 60Hz 20A

**PRODUCT CLEARANCES
The factory set 115° door swing can be adjusted to 90° if clearance to adjacent cabinets or walls is restricted.

GROUNDING THE REFRIGERATOR

IMPORTANT—PLEASE READ CAREFULLY
FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED.
The power supply cord of this appliance is equipped with a three-prong (grounding) plug which mates with a standard three-prong (grounding) wall receptacle to minimize the possibility of electric shock hazard from this appliance. Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.
Where a standard 2-prong wall outlet is encountered, it is your personal responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet.

DO NOT UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE THIRD (GROUND) PRONG FROM THE POWER CORD.
DO NOT USE AN ADAPTER PLUG TO CONNECT THE REFRIGERATOR TO A 2-PRONG OUTLET.
DO NOT USE AN EXTENSION CORD WITH THIS APPLIANCE.

DIMENSIONS AND INSTALLATION (FULLY INTEGRATED INSTALLATION)

FLOORING
For proper installation, this refrigerator must be placed on a level surface of hard material that is at the same height as the rest of the flooring. This surface should be strong enough to support a fully loaded refrigerator, or approximately 1500 lbs.
NOTE: Protect the finish of the flooring. Cut a large section of the cardboard carton and place under the refrigerator where you are working.
WATER AND ELECTRICAL LOCATIONS
The opening must be prepared with the electrical and water supply located as shown.
FINISHED RETURN OF 6″ REQUIRED
A minimum 6″ (15.2) finished return matching cabinet exterior recommended on interior on all sides and top at front of opening
ADDITIONAL SPECIFICATIONS
A 120 volt, 60Hz, 15 or 20 amp power supply is required. An individual properly grounded branch circuit or circuit breaker is recommended.
Install a properly grounded 3-prong electrical receptacle recessed into the back wall. Electrical must be located on rear wall as shown.

NOTE: GFI (ground fault interrupter) is not recommended. Water line can enter the opening through the floor or rear wall. The water line installed should be 1/4″ O.D. copper tubing or GE Smart Connect™ tubing between the cold water line and water connection location. The line should be long enough to extend to the front of the refrigerator. Installation of an easily accessible shutoff valve in the water line is required.

DIMENSIONS AND INSTALLATION (STANDARD INSTALLATION)

FLOORING
For proper installation, this refrigerator must be placed on a level surface of hard material that is at the same height as the rest of the flooring. This surface should be strong enough to support a fully loaded refrigerator, or approximately 1500 lbs.
NOTE: Protect the finish of the flooring. Cut a large section of the cardboard carton and place under the refrigerator where you are working.
WATER AND ELECTRICAL LOCATIONS
The opening must be prepared with the electrical and water supply located as shown.
ADDITIONAL SPECIFICATIONS
A 120 volt, 60Hz, 15 or 20 amp power supply is required. An individual properly grounded branch circuit or circuit breaker is recommended.
Install a properly grounded 3-prong electrical receptacle recessed into the back wall. Electrical must be located on rear wall as shown.
**SINGLE INSTALLATION ACCESSORY KIT**
ZKW36V: Single Installation retrofit/standard installation (required when installing in a 35 1/2″ wide and 24″ deep cut-out.)
Product at Standard trim is 36 13/16″ (93.5 cm) wide, 28 3/8″ (72.1 cm) deep, and 84 1/2″ (214.6 cm) height.

NOTE: GFI (ground fault interrupter) is not recommended. Water line can enter the opening through the floor or rear wall. The water line installed should be 1/4″ O.D. copper tubing or GE Smart Connect™ tubing between the cold water line and water connection location. The line should be long enough to extend to the front of the refrigerator. Installation of an easily accessible shutoff valve in the water line is required.

Customer Support

For answers to your Café™ product questions, visit our website at cafeappliances.com.

References

• Café Appliances

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>