GE current IND673 ProLine Daintree EZ Connect Kit Instruction Manual
- June 9, 2024
- GE current
Table of Contents
GE current IND673 ProLine Daintree EZ Connect Kit
ProLine® Daintree EZ Connect Kit
Applicable Fixture Types: LWS and PSF Series. Only for New Construction.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
RISK OF ELECTRIC SHOCK
- Turn power off before inspection, installation or removal.
- Properly ground electrical enclosure.
RISK OF FIRE
- Follow all NEC and local codes.
- Use only UL approved wire for input/output connections. Minimum size 18 AWG (0.75mm2).
Save These Instructions
Use only in the manner intended by the manufacturer. If you have any
questions, contact the manufacturer.
Components Supplied
- EZ Connect Kit
Prepare Electrical Wiring
Electrical Requirements
- The LED luminaire must be connected to the mains supply according to its ratings on the product label.
Grounding Instructions
- The grounding and bonding of the overall system shall be done in accordance with National Electric Code (NEC) Article 600 and local codes.
Installation
- Follow instructions provided with fixture to access LED driver enclosure.
- Remove knockout from end of fixture and pass wires and conduit from kit into fixture. Secure conduit to fixture with provided conduit nut.
- Make the following electrical connections:
- ground from the kit to the fixture ground
- pink and purple from the kit to the pink and purple from the LED driver
- red wire from the kit to the black line from the LED driver
- white wire from the kit to the white neutral from the LED driver
- Connect the building line, neutral and ground to the kit line, neutral and ground shown below.
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference,
- this device must accept any interference received, including interference that may cause undesired operation. CAN ICES-005 (A) / NMB-005 (A)
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at their own expense.
www.gecurrent.com © 2021 Current Lighting Solutions, LLC. All rights reserved. GE and the GE monogram are trademarks of the General Electric Company and are used under license. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions. IND673 (Rev 12/13/2021) DOC-2002361 | REV-01
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>