ARCADE1up ATR-E-20650 Atari Couchcade Wireless Retro Game Station Owner’s Manual
- June 9, 2024
- ARCADE1UP
Table of Contents
1up ATR-E-20650 Atari Couchcade Wireless Retro Game Station
Owner’s Manual
ATR-E-20650 Atari Couchcade Wireless Retro Game Station
WARNING
To ensure safe operation of the product, be sure to read this Owners Manual
before use.
Keep this Owners Manual in a safe place for easy reference when needed.
CONTROL DECK SET UP
- Install 4 “AAA” batteries (Not Included) in the battery compartment on the side of the Control Deck.
BATTERY INSTALLATION
- MAKE SURE CONTROL DECK IS TURNED OFF OR IN AUTO OFF MODE
- REMOVE BATTERY BOX COVER BY PHILLIPS HEAD SCREWDRIVER
- INSERT 4 AAA ALKALINE BATTERIES IN THE BATTERY BOX AS ILLUSTRATED MAKING CERTAIN THAT NEGATIVE(-)AND POSITIVE (+) POLES ARE POSITIONED PROPERLY
- REPLACE BATTERY BOX COVER -BE SURE NOT TO OVER-TIGHTEN THE SCREW
WARNING – BATTERY-OPERATED
BATTERY SAFETY NOTICE
- Non-rechargeable batteries are not to be recharged.
- Rechargeable batteries are to be removed from the device before being charged (if removable).
- Rechargeable batteries are only to be charged under adult supervision.
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
- Only batteries of the same or equivalent types, as recommended are to be used.
- Batteries are to be inserted with the correct polarity (+ and -).
- Remove batteries before storing.
- Exhausted batteries are to be removed from the device.
- Always use alkaline batteries.
- Do not dispose of batteries in fire, batteries may explode or leak.
- The supply terminals are not to be short-circuited.
CONNECTING GAME CONSOLE TO TV
- Connect HDMI cable (Included) to TV and Game Console (make sure the devices are OFF).
- Connect Micro USB cable (Included) to TV or USB power adaptor (not included).
- Press Power Button on top of Game Console to power ON. The power indicator light on top of Game Console will light up RED and then TV will enter the game.
NOTE: Make sure your TV is on the correct HDMI auxiliary input and set with 16:9 scale.
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s).
Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation of the device.
FCC/ISED STATEMENT
This device complies with part 15 of the FCC rules / Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC/ISED rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
EPILEPSY WARNING
A very small percentage of individuals may experience epileptic seizures or
blackouts when exposed to certain light patterns or flashing lights.
Exposure to certain patterns or backgrounds on a television screen or when
playing video games may trigger epileptic seizures or blackouts in these
individuals. To reduce the risk of such a seizure incident, it is recommended
to take a 10-15 minute break at each hour of playing.
PAIRING YOUR CONTROL DECK TO GAME CONSOLE
-
Turn ON the power switch on the Control Deck.
-
Press Power Button on top of Game Console to power ON. The power indicator light on top of Game Console will light up RED and then TV will enter the game.
NOTE: Make sure your TV is on the correct HDMI auxiliary input and set with 16:9 scale. -
The LED of Control Deck will change BLINKING to SOLID when paired.
-
If the units fail to pair, turn them both OFF and repeat Step 1-3 again or refer below “Pairing Mode”.
LED LIGHT INDICATION
| Game Console| Control Deck
---|---|---
Solid Light Up| Power On| Power On + Paired
-
Slow Flashing| x| Battery Low
Normal Flashing| x| Waiting Connection Mode
Fast Flashing| x| Pairing Mode
Light Off| Power Off| Sleep Mode / Power Off -
Slow Flashing LED during game play indicates low battery, recommend to replace batteries.
Pairing Mode:
If Game Console & Control Deck cannot be paired, please hold Player 1 & 2 buttons at the same time then turn ON the power switch of Control Deck. Once connected
successfully, indicator light will light up SOLID RED.
SLEEP MODE
CONTROL DECK goes to SLEEP MODE after 10 minutes of inactivity.
(press any button to wake up CONTROL DECK or turn off the POWER SWITCH to conserve batteries for future play).
ASSISTANCE OR SERVICE
If you have questions regarding your Arcade1Up product or require technical
support, contact Arcade1Up Customer Service at
www.Arcade1Up.com and click on “Support”.
CAUTION
Servicing instructions are for use by qualified service personnel only. To
reduce the risk of electric shock, do not perform any servicing other than
that contained in the
operating instructions unless you are qualified to do so.
The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc. in the United States and other countries.
GAME CONTROLS
*ARCADE MAY TAKE 10-15 SECONDS TO POWER ON AFTER SWITCHING ON
- PRESS A BUTTON TO CHOOSE GAME
- ROLL TRACKBALL UP AND DOWN TO SCROLL THROUGH GAME LIST
- HOLD PLAYER 1 (5 SECONDS) TO RETURN TO MENU AND TO SAVE A HIGH SCORE
- FOLLOW GAME CONTROLS BELOW FOR EACH GAME
- HOLD PLAYER 2 (5 SECONDS) TO RESET GAME
| 
---|---
FCC RF RADIATION EXPOSURE STATEMENT:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator and any part of your body.
ISED RF RADIATION EXPOSURE STATEMENT:
This equipment complies with IC RSS-102 radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and
operated with a minimum distance of 20cm between the radiator and any part of
your body.
This unit is only to be connected to equipment bearing either of the following
symbols:
TROUBLESHOOTING
| PROBLEM | POSSIBLE CAUSE | SOLUTION |
|---|---|---|
| Game Console will not turn on. | -Game Console is not turned ON. |
-Game Console is not plugged in via the Micro USB cable (Included).
-Game Console HDMI is not connected to TV or on correct TV input source.| -Press button on top of Game Console to turn ON.
-Make sure the Game Console is plugged intoa 5V power supply via the Micro USB cable (Included).
-Make sure the HDMI cable is connected to your TV and make su re your1V is on the correct input source.
Control Deck will not turn on.| – No batteries in batterycompartment on
Control Deck.
-Batteries are out of power.
-ON/OFF Switch is in the OFF position. – Batteries are inserted incorrectly.| -Insert batteries 4 “AAA” on side of Control Deck. -Replace to new batteries.
-Slide ON/OFF Switch located on Control Deck to the ON
-Make position.
sure batteries are to be inserted with the correct polarity.
Control Deck will not pair to the
Game Console.| -Control Deck needs to be re-paired to the Game Console.| -If
Control Deck and Game Console cannot be paired, please hold Player 1 & 2
buttons down at the same time then turn ON the power switch of the Control
Deck. Once connected sucessfully, indicator will light up SOLID RED.
Joystkk, Spinner or Trackball are not
responding.
Control Deck indicator light is slow
flashing.| – Batteries in the Control Deck battery compartment are getting
tting low and need to be replaced.| -Replace batteries in the Control Deck
battery compartment with 4 new “AAA” batteries.
Game will turn ON, but there is no sound.| -Volume Switch is in the OFF
position.| -Slide Volume Switch located on Control Deck to the right
the NOTE: sl ide volume switch up to increase volume, down to lower volume.
The game screen is frozen.| -The game encountered a problem when
processing the data.| -You may need to RESET the game. Turn the ON/OFF switch
to the OFF position and then back ON again on both the Game Console and
Control Deck.
One of the buttons on the Control Deck is
stuck in the down position.| -Debris may have gotten between the button and
the button housing.| -Take something thin (like a business card) and place
It between the button and the button housing and
slide it back and forth to loosen the debris.
You are not able to scroll through the
games on the game selection menu.| You may be pressing the incorrect buttons
to scroll through the games.| -Look at the game control section in the
instruction manual to make sure you are pressing the correct buttons to scroll
through thegame selection menu.
You are able to scroll through the games
on the game selection menu, but you
can’t enter a game to begin playing.| You may be pressing the wrong button
to enter the game.| -Look at the game control section in the instruction
manual to make sure you are pressing the correct button to enter the game.
You have entered the game, but you
can’t get the game to start.| -You may be pressing the wrong button to start
the game.
-Your TV does not support 1366 x 768 resolution.| -Look at the game control section in the instruction manual to make sure you are pressing the correct button to start the game.
-Try to connect to other TV (1080p or higher).
-You may be pressing the wrong button to You have entered the game, but you . .
can’t exit the game to get back to game _exit tne game. You may not be holding
down the exit selection menu. button long enough.| -Look at the game control
section in the instruction manual to make sure you are pressing the correct
button to exit the game.
-Make sure you are holding the exit button down for 5 seconds to exit the ga me.
The control functions that are printed on
the Control Deck do not match the
gameplay on the screen for the game
you are playing.| -Yo may be pressing the wrong ame
game control buttons for the game you are playing.| -Look at the game control
section in the instruction manual to make sure you are pressing the correct
game control buttons for that game.
-Look at the game control loading screen on the monitor to make sure you are pressing the correct control buttons.
(NOTE: The game controls that are printed on the
Control Deck are only for the feature cabinet game. The other games in the
cabinet will utilize the same buttons but react differently.)
The game will not let me select 2 or 3
players for a chosen game.| – The game may only be a 1 or 2 player game.|
-Refer to the game control section in the instruction manual to see how many
players are able to play that game.
COLLECT THEM ALL
Colors, style and decoration may vary.
visit Arcade1up.com
TO SIGN UP FOR OUR MAILING LIST AND
SEE A COMPLETE LIST OF GAMES Tempest®, Centipede®, Asteroids®, Asteroids
Deluxe®, Millipede®,
Crystal Castles®, Major Havoc®, Missile Command®, Gravitar®, and Lunar
Lander®
are all registered trademarks owned by Atari Interactive, Inc. ©2021 Atari
and the
Atari logo are registered trademarks owned by Atari Interactive, Inc. All
rights reserved.
TASTEMAKERS,LLC.
347 Fifth Avenue, Suite 1402-199, New York, NY 10016
Documents / Resources
|
ARCADE1up ATR-E-20650 Atari Couchcade Wireless Retro Game
Station
[pdf] Owner's Manual
ATR-E-20650, Atari Couchcade Wireless Retro Game Station, Wireless Retro Game
Station, Atari Couchcade, Retro Game Station, Game Station, Station
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>