Schneider Electric CCT5010-0002 Wiser Micro Module Dimmer User Manual

: June 9, 2024
: Schneider Electric

Table of Contents

Schneider Electric CCT5010-0002 Wiser Micro Module Dimmer
About this product
Technical data
Trademarks
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Schneider Electric CCT5010-0002 Wiser Micro Module Dimmer

About this product

The Wiser micro module dimmer (hereinafter referred to as puck) is used to used to switch and dim the ohmic, inductive or capacitive loads.
Note: Do not control any devices that depends on a permanent power supply. Connect a maximum of 10 mechanical push buttons to the puck to provide direct operation.

Check nominal power rating for load type

Choose a suitable location to install

If you place the puck behind a mechanical push button, choose a wall box deep enough to fit both the puck and switch mechanism.

Note: T o reduce the thermal dissipation, reduce the load.

Wiring diagram and electrical connections

DANGER

HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
Safe electrical installation must be carried out only by skilled professionals. Skilled professionals must prove profound knowledge in the following areas:

Connecting to installation networks.
Connecting several electrical devices.
Laying electric cables.
Safety standards, local wiring rules and regulations.
Failure to follow these instructions will result in death or serious injury.

HAZARD OF ELECTRIC SHOCK

Make sure that the terminal connection area does not come in contact with the metallic parts of any device installed in the same location.
Do not short the outputs to neutral.
Failure to follow these instructions will result in death or serious injury.

CAUTION

EQUIPMENT DAMAGE

Always operate the product in compliance with the specified technical data.
Never connect any mixed inductive/capacitive loads.
Connect only dimmable loads.
Do not use dimmable socket outlets.

Failure to follow these instructions can result in injury or equipment damage.

Live conductor
Dimmer output
Mechanical push button input

Note: The dimming result will be depending on the LED connected. Some LEDs will not work properly. This depends on number of LEDs, the quality of the driver and the power of network it is supplied from.

Test puck operation

WARNING

HAZARD OF ELECTRIC SHOCK

Observe the regulations for working on live parts.
Only actuate the device buttons using insulated auxiliary equipment that meets the requirements of EN 60900.

Failure to follow these instructions can result in death, serious injury, or equipment damage.

% Read full device guide online

Scan the QR code and choose your language for complete information about the device, including operation, configuration and pairing the device to a Wiser system.

Technical data

Schneider Electric CCT5011-0002 Wiser Micro Module Light Switch-
fig-6

Trademarks

Zigbee® is a registered trademark of the Zigbee Alliance.
Wiser™ is a trademark and the property of Schneider Electric SE, its subsidiaries and affiliated companies.

Other brands and registered trademarks are properties of their relevant owners.

EU Declaration of Conformity
Hereby, Schneider Electric Industries, declares that this product is in compliance with the essential requirements and other relevant provisions of RADIO EQUIPMENT DIRECTIVE 2014/53/EU. Declaration of conformity can be downloaded on: se.com/docs

Schneider Electric Industries SAS
If you have technical questions, please contact the Customer Care Centre in your country. se.com/contact