smeg MFF01 Milk Frother User Manual
- June 9, 2024
- Smeg
Table of Contents
USER MANUAL
MILK FROTHER
MFF01 Milk Frother
We advise you to read this manual carefully, as it contains all the
instructions for managing tha appliance’s aestetic and functional qualities.
For further information on the product: www.smeg.com
Dear Customer,
Thank you very much for purchasing the Smeg Line Milk Frother.
By choosing our product, you have opted for a solution in which aesthetics and
innovative technical design offer unique objects, which become part of the
furnishings.
In fact, a Smeg household appliance always co-ordinates perfectly with other
products in the range and, at the same time, can become a design object for
the kitchen.
We hope you fully appreciate the functionalities of your appliance. Best
regards.
SMEG S.p.A.
**** Recommendations
SAFETY
Essential safety recommendations.
Since the appliance operates with electric current,the following safety
recommendations must befollowed:
- Do not touch the plug with wet hands.
- Make sure that the power outlet used is always freely accessible, so that it can it be unplugged when necessary.
- Never pull the cable, it could be damaged.
- If the appliance should break down, do not attempt to repair it. Switch the appliance off, remove the plug from the power outlet and contact the Technical After-sales centre.
- If the plug or power supply cable are damaged, have them replaced exclusively by the Technical After-sales centre, so as to prevent all risks.
- Do not immerse the appliance in water.
- Attention: disconnect the plug before cleaning.
- Do not allow the power supply cable to dangle over the edge of the table or other surface or to touch hot surfaces.
- Keep the packaging material (plastic bags, expanded polystyrene) out of the reach of children.
- Do not allow use of the appliance by persons (including children) with reduced physical and sensory conditions or lack of experience and knowledge, unless they are carefully supervised or instructed by a person responsible for their safety. Control children, making sure they do not play with the appliance.
- Do not place the appliance on or in proximity of electric or gas cookers, or in a heated oven.
- Verify that there are no foreign objects inside the appliance.
- Do not fill the carafe excessively, but always refer to the level indications etched inside the carafe itself. Filling beyond the limit indicated could be dangerous if the frothed milk splashes out of the container.
- The carafe heats up during use. Do not touch the hot surfaces, always hold the carafe by its handle.
- People with pacemakers or other similar devices must ensure that operation of their device is not jeopardised by the inductive field, the frequency of which is between 20 and 50 Hz.
- The milk frother disc can be a cause of suffocation. Keep out of the reach of children.
Connect the appliance
Make sure that the mains voltage and the frequency corresponds with those
indicated on the data plate on the bottom of the appliance. Only connect the
appliance to a current outlet installed perfectly with minimum capacity of 10A
and with an efficient earth. In the event of incompatibility between the
outlet and the plug on the appliance, ontact the technical after-sales service
for replacement.
For European markets only:
- This appliance can be used by children aged 8 and upwards if supervised or instructed regarding safe use of the appliance and they understand the risks connected.
- Cleaning and maintenance can be carried out by children of 8 years and upwards as long as they are supervised.
- Keep the appliance and its cable out of the reach of children under 8 years of age.
- Children must not play with the appliance.
- Disconnect the appliance from the power outlet before all assembly, disassembly and cleaning operations.
Use compliant with destination
This appliance is intended to heat and froth milk and to prepare hot
chocolate. Do not us the product for purposes different to its intended use.
This appliance is intended for domestic use only.
Manufacturer’s liability
The manufacturer declines all liability for damage undergone by persons and objects due to:
- use of the appliance different from that envisioned;
- user manual has not been read;
- tampering of individual parts of the appliance;
- use of non-original spare parts;
- failure to comply with safety recommendations.
Keep these instructions carefully.
Whenever the appliance is trans- ferred to other persons, they must also be
given these user instructions.
DISPOSAL
Electrical appliances must not be disposed of withhousehold waste.
The appliances that have this symbol are subject to the European Directive
2012/19/EU. All discarded electric and electronic appliances must be disposed
of separately from household waste, by taking them to relevant centres
envisioned by the Country. By disposing of the discarded appliance correctly,
damage to the environment and risks to health will be avoided. For further
information regarding disposal of the discarded appliance, contact the
Municipal Administration, the Disposal dept. or the shop where the appliance
was purchased.
Description/Assembly
DESCRIPTION OF THE APPLIANCE (Fig.1)
-
Motor base
-
Carafe
-
Notched whisk (for frothing the milk or the chocolate)
3a Smooth whisk (for hot milk function) -
Lid
-
Measuring cap
-
START/STOP button
-
Program selection knob
-
LED
IDENTIFICATION PLATE
The identification plate states the technical data, the serial number and
marking. The identification plate must never be removed.
BEFORE COMMISSIONING (Fig.1)
- Unpack the appliance carefully and remove all packaging materials and any labels and stickers.
- Clean the motor base (1) using a damp cloth.
Wash all components and dry thoroughly (see paragraph “Cleaning and Maintenance”).
Before use, check that all components are integral.
ASSEMBLY OF COMPONENTS (Fig. 1)
- Position the carafe (2) on the motor base (1).
- Position the whisk (3) inside the carafe (2), inserting it into the relevant pin.
- Position the lid (4) on the carafe (2) and press it down.
DESCRIPTION OF CONTROLS (Fig. 1)
Program selection knob (7)
The appliance has 6 pre-set programs and a manual function, which can be
selected using the knob (7).
Knob icon | Program |
---|---|
Hot chocolate | |
Hot milk | |
Hot milk with light froth | |
Hot milk with dense froth | |
Cold milk with light froth | |
Cold milk with dense froth | |
Manual |
Liquid level indications
Symbol | Description |
---|---|
Maximum milk level for heating and chocolate preparation functions |
(including the amount of chocolate).
| Maximum level of milk to be frothed.
| Minimum level.
Use
USE (Fig. 1)
Recommendations for use
The result of the milk frother function may be affected by the ingredients
used.
For a good result, it is recommended to use full-fat milk and to take it from
the fridge immediately before pouring it into the carafe (2).
After a first heating cycle, wait for the appliance to cool down before
starting another cycle.
Do not use the appliance without liquids. Starting the appliance without
liquids could damage the pitcher.
Always fill up to the MIN level and not over the MAX level; both indicated
inside the pitcher.
If the LED on the knob flashes and three acoustic signals are repeated
twice, it means that the appliance is in error status. The error status is
shown if the pitcher or whisk are not present, the pitcher is removed during
preparation or the cycle is started with the pitcher empty. In the first two
cases, the cycle does not start, while in the second two, the cycle starts but
stops after a few seconds.
- Insert the plug into the power outlet.
- The LED (8) flashes, after approx. 120 seconds of inactivity the appliance goes to stand-by and the LED switches off.
Heat or froth the milk
- Remove the lid (4) and pour cold milk into the carafe (2), with reference to the level indications etched inside the carafe itself.
- Re-mount the lid (4).
- Select the desired program by turning the knob (7) in correspondence with the red notch on the knob lock nut.
From the stand-by phase, the appliance goes to processing phase.
- Press the START/STOP button (6) to start the cycle, the LED (8) has a fixed light.
- An acoustic signal and the switching off of the LED (8) indicate the end of the cycle.
- The cycle can be stopped before time by pressing the START/STOP button (6).
- Remove the lid (4) gripping the lateral tabs.
- Remove the carafe (2) and pour the frothed milk with the aid of a spoon.
The addition of sugar or sweetening syrups (e.g. honey, agave juice or maple syrup etc.) is recommended at the end of the cycle.
Preparing chocolate
- Remove the lid (4) and pour the hot chocolate ingredients inside the pitcher (2), referring to the level indicators printed inside the pitcher and the suggestions indicated in the Smeg recipe.
- Select the relative program and proceed according to that described for milk.
During the working phase, it is possible to remove the measuring cap (5) to add powdered ingredients. We recommend adding powdered ingredients slowly and in small quantities a few moments after the
Cleaning and maintenance
cycle starts so that the milk starts to become warm. If the dried ingredients are added too fast or in large quantities, the rotation of the whisk may stop or detach from its base.
Manual function
-
Remove the lid (4) and pour milk into the pitcher (2), make sure to refer to the level indications printed on the inside of the pitcher.
-
Put the lid back on (4).
Hot or cold cycles can be selected.
Hot Manual: -
To start the manual program (M), with heating function, press the START/STOP button, the LED (8) switches on with a fixed light; the whisk speed and temperature increase proportionally to the duration of the cycle. The user can stop the cycle by pressing the START/STOP button as soon as he decides preparation is satisfactory.
Cold Manual: -
By holding the START/STOP button down for approx. 3 seconds; the whisk starts up to froth the milk without heating it and the LED (8) flashes for the entire duration of the cycle. The user can stop the cycle by pressing the START/STOP button as soon as he decides preparation is satisfactory.
-
In both cases, after a certain period of time, the manual function is interrupted automatically to preserve safety and functionality of the product.
-
An acoustic signal and the switch- ing off of the LED (8) indicate the end of the cycle.
-
Successively, proceed according to that described for the milk.
During the working phase, it is possible to remove the measuring cap (5) to add powdered ingredients (e.g. soluble coffee, soluble cappuccino, soluble tea, etc.).
CLEANING AND MAINTENANCE (Fig. 1)
**** Before carrying out any cleaning operation, ALWAYS disconnect the plug
from the power outlet and allow the appliance to cool down. Never immerse the
motor base (1) in water or other liquids.
The instruction manual contains appropriate instructions and measures for
cleaning and maintenance operations and operations recommended to the customer
by the producer. Any other intervention must be performed by a representative
of an authorised service centre.
- Remove the whisk (3).
- Remove the carafe (2) from the motor base.
- The whisk (3), the lid (4), the measuring cap (5) and the pitcher (2) are dishwasher safe.
- The motor base (1) can be cleaned by first using a damp cloth and then a dry one. Do not use detergents or abrasive materials.
Recipe book
HOT CHOCOLATE
For two cups
Ingredients
– Full fat milk 250 ml
– Flakes of dark chocolate 90 g
Preparation
- Pour the milk into the pitcher.
- Add the flakes of chocolate.
- Close the lid.
- Select the hot chocolate program ( ).
- Press the START/STOP button and wait for the program to end.
CAPPUCCINO
For two cups
Ingredients
– Full fat milk
– Coffee or “ristretto” coffee| 200 ml
80 ml
40 ml
---|---
Preparation
- Dispense the coffee from a coffee machine and pour it into a cup.
- Pour the milk into the milk frother.
- Close the lid.
- Select the hot milk with thick froth program .
- Press the START/STOP button and wait for the program to end.
- Pour the frothed milk onto the coffee.
- Add sugar or sweetening syrup as desired.
ICED ESPRESSO MACCHIATO
For two cups
Ingredients
– Full fat milk
– Coffee or “ristretto” coffee| 200 ml
80 ml
40 ml
---|---
Preparation
- Put the ice cubes into 2 glasses.
- Dispense the coffee from a coffee machine and pour it over the ice in the glasses.
- Add sugar or sweetening syrup as desired.
- Pour the milk into the milk frother.
- Close the lid.
- Select the cold milk with thick froth or with light froth program as desired ( / ).
- Press the START/STOP button and wait for the program to end.
- Pour the frothed milk into the glasses with the coffee and ice.
What To Do If…..
Problem | Possible causes | Solution |
---|
The appliance does not
work.| Plug not connected.| Connect the plug.
The appliance stops during operation.| The pitcher is empty.| Fill the
pitcher.
The pitcher has been removed during preparation.| Re-position the pitcher
appropriately.
Ingredients too dense or large, such as large chocolate
flakes.| Use finer ingredients.
The cycle does not start.| The pitcher is not present.| Re-position the
pitcher appropriately.
The whisk is not present.| Check that the whisk is present and positioned
correctly.
The milk does not froth.| Milk not cold.| Use cold milk.
The pitcher contains water residues or is dirty.| Make sure that the pitcher
is dry and clean.
The whisk used is not correct.| Mount the notched whisk.
Use of milk already frothed or heated.| Do not use milk already frothed or
heated.
Use of low-fat milk.| Use suitable milk.
The ingredients do not
melt.| Ingredients too thick or excessive amount introduced.| Chop the
ingredients before introducing them or check preparation suggestions.
If the problem cannot be solved or for other types of faults, contact the
local after-sales service.
The manufacturer reserves the right to make any changes deemed useful for the
improvement of its products without priornotice. The illustrations and
descriptions contained in this manual are therefore not binding and are merely
indicative.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>