DIY Caravans Freucamp Skylight 400×400-Manual 3 Installation Guide
- June 9, 2024
- DIY CARAVANS
Table of Contents
DIY Caravans Freucamp Skylight 400×400-Manual 3 Installation Guide
MAIN COMPONENTS
- Dome (Acrylic)
- Push Rod Arm
- Push Rod
- Upper Frame
- Ambient Light
- Blind Frame
- Installation Frame
- Latch Hook
- Damping Block
- Power Button
- Pleated Blind
- Pleated Flyscreen
Security Considerations
Please read this manual carefully before installation, and first use ,and store it in a safe place. If you pass on the product to another person, hand over this instruction manual along with it. In order to avoid property damage to users and others, please strictly follow the safety warnings and precautions.
Warning!
- The ambient light must be connected to a DC12V power supply and the power supply must be correctly connected. Otherwise, the product may be damaged or cause a fire.
- Please lock the dome of the roof window before driving, otherwise the acrylic may be damaged when driving.
Attention!
- Please close the dome of the roof window on rainy days, or open the top cover to the ventilated gear, but you need to switch the skylight from the ventilated gear back to the close when driving.
- The push rod can withstand a maximum pull-down force of 30kg. Do not hang heavy objects on the push rod.
- When closing the dome, please pull down the push rod to the end, make sure that both ends are stuck in the corresponding position and make a clicking sound, and make sure that the push rod is completely locked.
- If faults or disturbances occur, consult a specialist workshop immediately.
- Before starting your journey, check the roof window for damage (such as tension cracks in the acrylic glass).
- Do not open the window in strong wind or rain.Close the roof window if it rains or snows. Do not leave the vehicle with the roof window open.Keep the roof window free of snow and ice.
ROOF WINDOW USE
OPEN THE DOME
CLOSE THE DOME
WARNING SIGN
PRODUCT SIZE
PACKING LIST
Install Instructions
-
According to the hole size drawing on the product size page, cut the installation hole on the roof (a solid wall 30mm wide is required around the opening so that the screw can be firmly nailed into the wall), and you can choose to install it on the left or right (reserve a room for a power cord 50mm in the side hole).
-
After observing the position of the touch switch on the mounting frame, confirm the direction of the mounting frame according to the reserved position of the power cord (the switch position and the reserved line position are on the same side), and use 15 ST4.0x16 self-tapping screws from the inside car to fix the mounting frame on the roof, and check whether the mounting frame is fixed well to the roof.
-
Connect the reserved cord to the touch panel power cord and wrap it with electrical tape, and use a 4mm wide cable tie to tie the excess power cord to the fixed point of the light guide (there are fixed points on the left and right sides), and check whether the light strip works normally after power on.
-
Apply a ring.
-
Clean the oil and dust on the roof mounting surface.
-
Use self tapping scres to fix the upper part of the roof window from inside.
WARRANTY STATEMENT
Aussie Traveller Pty Ltd ACN 642 775 460 (Aussie Traveller through an authorised manufacturer, dealer or approved service repair agent (Product).
Australian Consumer Law
luded. Nothing in this warranty is to be interpreted as excluding, restricting or modifying any State or Federal legislation applicable to the Our goods come with guarantees that cannot be excluded under the amount to a major failure.
Warranty
Aussie Traveller warrants that, subject to the exclusions and limitations below, all parts of the manufacture and assembly of the Product will be free from defects in materials and workmanship (Warranty) for a period of 12 months from the date of purchase as follows: In the event the Product is purchased by a manufacturer, dealer or approved service repair agent, this Warranty will commence at the will commence at the time of the original purchase.
Warranty Period
This Warranty cannot be assigned or transferred to a subsequent owner of the Product. free from any damage or defect, and matches the description provided. If after accepting the Product, a defect appears in the manufacture or assembly of the Product before the end of the Warranty Period and replace, repair or refund the Product or the defective part of the Product free of charge.
In arranging Warranty inspection, service and repair, Aussie Traveller will seek to provide the details of an approved service agent within your geographic area. Should one not be available, or if the Product is in use in travel, Aussie Traveller reserves the right to seek to arrange a repair or replacement at the next available location on the route of travel. Aussie Traveller reserves the right to replace defective parts of the Product with parts and components of similar quality, grade and composition where an identical part or component is not available. Products presented for repair may be replaced by refurbished goods of the same type rather than being repaired. Refurbished parts may be used to repair the Product.
Aussie Traveller Awning Products
-
The vinyl fabric is warranted against:
a. holes caused by mildew (mildew will form on dust and dirt and stain fabric if fabric is not kept clean).
b. excessive cracking, peeling, hardening or loss of strength while used under normal conditions.
c. excessive fading (a slight colour change may occur due to ultraviolet rays). -
All hardware components including the roller are warranted not to bend or break under normal use (excluding high winds, water pooling and accidents)
Making a Warranty Claim
defect. Aussie Traveller will assist the Customer to rectify and resolve any Product issue that may arise. When making a claim under this Warranty, Aussie Traveller requires that the following information be provided before any further action will be taken.
- Original Invoice (Document or Number);
- Make and model of the Product;
- Vehicle chassis number;
- Description of damage and/or repair required;
- Photos of the damage and/or repair; and
- Appropriate documentation (such as historical and maintenance records).
Exclusions
This Warranty will not apply where:
-
Traveller or an authorised repair agent; the alleged defect in the Product is within acceptable industry tolerances and variances;
-
Aussie Traveller cannot establish any fault in the Product after testing and inspection;
-
the Product has been used other than for the purpose for which it was designed; maintenance schedules); pressure, stress or similar;
-
the alleged defect has arisen due to abuse, misuse, neglect or accident;
unauthorised parts or accessories have been used on or in relation to the Product; -
the Product has been overloaded or involved in an accident;
-
the alleged damage or defect has been caused by normal wear and tear;
-
the alleged damage to fabric has been caused by storm, wind or rain, or stretching of fabric caused by water pooling on fabric;
-
breakage or bending of hardware components has been caused by storm, wind or rain, or water pooling on fabric.
Replacement Warranty Item
If, under Warranty, a Product is replaced or repaired by Aussie Traveller or
an Aussie Traveller agent, unless provided in writing to indicate otherwise,
the replacement Product will carry the remaining Warranty terms and
conditions, including length of time, of the original purchased Product.
Change of Mind items purchased by mistake or “change of mind” reasons may not
be approved. Aussie Traveller will not accept Product returns under these
circumstances unless by written approval by an authorized Aussie Traveller
representative. If approved, an administration and restocking fee may apply
Limitations
Aussie Traveller makes no express warranties or representations other than set out in this Warranty.
Contact
Australia Wide: 1300 663 868
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>