FS S3150-8T2FP 8 Port Fanless Gigabit Managed PoE Plus Switch User Guide
- June 9, 2024
- FS
Table of Contents
FS S3150-8T2FP 8 Port Fanless Gigabit Managed PoE Plus Switch
Overview
Stipulation
Format Stipulation in the Command Line
Syntax | Meaning |
---|---|
Bold | Stands for the keyword in the command line, which stays unchanged and |
must be entered without any modification. It is presented as a bold in the
command line.
{italic}| Stands for the parameter in the command line, which must be replaced
by the actual value. It must be presented by the italic in the brace.
NTP Configuration
Overview
Network Time Protocol (NTP) is a type of computer time synchronization protocol which can be used for time synchronization between distributed time servers and clients. It has highly accurate time correction function and can prevent malicious protocol attacks through encrypted authentication. Clients and servers communicate through the User Datagram Protocol (UDP), and the port number is 123.
NTP Configuration
Configure the Equipment as an NTP Server
Configuration mode: Global
Command | Purpose |
---|
ntp master primary
| In the event that the equipment does not have an upper-level NTP server,
configure the equipment as the original NTP server (stratum = 1).
ntp master secondary|
In the event that the equipment has an upper-level NTP server, configure the equipment as the secondary NTP server.
(In other words, the equipment cannot provide time synchronization service for NTP clients unless the “ntp server” command is configured and time synchronization is achieved in designated servers.)
Configure NTP Authentication Function
Configuration mode: Global
Command | Purpose |
---|---|
ntp authentication enable | Enable the authentication function (disabled by |
default).
ntp authentication key keyid md5 password| Configure NTP md5 authentication
keyid and corresponding keys.
ntp authentication trusted-key keyid| Configure the keyid corresponding key as
the trusted key.
Configure NTP Association
Configuration mode: Global
Command | Purpose |
---|---|
ntp server ip-address [version number | key keyid]* |
of NTP server; the version number, key number, and the encryption key can be
designated.
ntp peer ip-address [version number | key keyid]*| The following command can
be used to configure NTP peer IP address of the device, designated version
number and key number.
Usage Guidelines:
- Equipment can provide time services for NTP clients provided that the equipment has achieved time synchronization; otherwise the client device that employs the equipment as its server cannot achieve time synchronization.
- To conduct NTP authentication, both parties must open the NTP authentication function simultaneously, configure the same key id and key, and designate the key id as trusted; otherwise time synchronization would fail.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>