Danfoss 014G2420 Ally Radiator Thermostat User Guide
- June 4, 2024
- Danfoss
Table of Contents
014G2420 Ally Radiator Thermostat
User Guide
Please use the manual provided with your gateway, and follow the instruction to download the App.
The adapters from the right box side are included.
The remaining adapters in the overview above must be purchased separately.
Adapter code numbers can be found below each adapter illustration.
How to mount the thermostat. Remove the battery cover as shown in the
diagram and insert two AA batteries. Make sure the batteries are correctly
oriented. Screw the Danfoss Ally™ onto the mounted adapter until a click sound
appears. Press and hold the button for 3 seconds. The temperature set point
will show on the screen once the Danfoss Ally™ is mounted.
CAUTION!
Mounting onto the valve must be done in “M” mode, otherwise, that could cause
the thermostat damage.
How to reset the thermostat.
- Remove the cover and take out one battery.
- Press and hold •, Keep holding while reinserting the battery. The screen will go blank after approximately 3 seconds.
Continue system set up in the App.
Download Guide
| Transmission Frequency: 2,4 GHz | Transmission Power: < 40 mW |
|---|---|
| The thermostat must be disposed of as electronic waste. |
Safety precautions
SIMPLIFIED EU DECLARATION OF CONFORMITY
Hereby, Danfoss A/S declares that the radio equipment type Danfoss Ally™ is in
compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the
following internet address: www.danfoss.com
The thermostat is not intended for children and must not be used as a toy. Do
not leave packaging materials where children may be tempted to play with them,
as this is extremely dangerous. Do not attempt to dismantle the thermostat as
it contains no user-serviceable parts.
Danfoss Ltd., 22 Wycombe End, HP9 1NB, GB
Homepage:
www.allyapprovals.danfoss.com
Danfoss cannot accept any responsibility for possible errors in catalogs, brochures, videos, and other material. Danfoss reserves the right to alter its products without notice. This also applies to products ordered but not delivered provided that such alterations can be made without changes to the form, fit, or function of the product. All trademarks in this material are property of Danfoss A/S or Danfoss group companies. Danfoss and the Danfoss logo are trademarks of Danfoss A/S. All rights reserved.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>