K7 RC Robotic Car Aluminum Alloy Remote Control Owner’s Manual
- June 9, 2024
- Robot
Table of Contents
K7 RC Robotic Car Aluminum Alloy Remote Control
CHARGER CONNECTOR
When charging, connect the USB cable with a white connector on the battery. the light is off and the light is on during charging , When the battery is fully charged.
use 3 AAA batteries
(not included)
Attention
-
Store the small parts properly.
-
If there is interference of wave, please move the robot to and the area.
-
When the car gets slower or the light turns dimmer, it’s time to Change “”” battery.
-
Do not expose the product in a place where nears fire, high temperature and humidity
-
Make sure to tum off the power Switch after use and remove the batteries.
-
Store the small parts properly.
-
If there is interference of wave, please move the robot to and the area.
-
when the car gets slower or the light turns dimmer, it’s time to dlange “”” battery.
-
Do not expose the product in a place where nears fire, high temperature and humidity
-
Make sure to tum off the power switch after use and remove the batteries.
OVERVIEW
(DLONG PRESS CYCLIC SWITCHING BUTTON: FIRST THE MECHANICAL VEHICLE HAS TO
CORRESPOND THE FREQUENCY, PRESS THE BUTTON TILL THE POWER LED OF THE TARGETED
MECHANICAL VEHICLE LIGHTS UP AND RELEASE THE BUTTON IMMEDIATELY TO CONTROL
THIS VEH ICLE. KEEP PRESSING THE BUTTON TO REPEAT /<:BOVE-MENTIONED OPERATIONS
TO SWITCH TO OTHER MODELS CYCLICALLY. @PUBLIC CHANNEL DOUBLE-CLICK: DOUBLE
CLICK THE BUTTON, THE POWER LED OF THE MECHANICAL VEH ICLE AFTER CORRESPONDING
FREQUENCYLIGHTS UP, THE PLAYER IS ABLE TO KEEP TAKING CONTROL.
◄ TURN LEFT-LONG PRESS TO CCELERATE
@DOUBLE CLICK THE BUTTON OF CHANNEL I TO SWITCH FROM OTHER MECHANICAL VEHICLES
TO KI /K4 MECHANICAL VEHICLE UNDER THE CONDITION OF CORRESPONDING FREQUENCY.
@DOUBLE CLICK THE BUTTON OF CHANNEL 2 TO SWITCH FROM OTHER MECHANICAL VEH
ICLES TO K2 MECHANICAL VEHICLE UNDER THE CONDITION OF CORRESPONDING FREQUENCY.
OPERATION STEPS: FIRST TURN ON THE POWER SWITCH OF THE MECHANICAL VEH ICLE,
AND THEN TURN ON THE REMOTE CONTROL POWER SWITCH. THE MECHANICAL INDICATOR AND
REMOTE INDICATOR TURN FROM FLASHING TO STEADY ON.
Time of charging: 90 m1ns Time of charging: 30 mtns The mec/lanicat battery
voltage is 7.4V.
BULLET ENTRANCE
K7 SERIES
