Schneider Electric 8RPM24200 Regulated Switch Power Supply Instruction Manual
- June 9, 2024
- Schneider Electric
Table of Contents
ABL 8RPS24pp0 / 8RPM24200 / 8WPS24p00
Instruction Manual
8RPM24200 Regulated Switch Power Supply
1 – 35 mm DIN rail mounting clip.
2 – Snap-on label.
3 – Voltage and output current. status LED Uout – Iout.
4 – Diagnostic Output (Normally Open dry contact 11-14)
U In| I out| ABL| | U In| I out| ABL|
---|---|---|---|---|---|---|---
1 Ph
~ 100…120 V| 3 A| 8RPS24030| | 1 Ph
~200…500 V| 3 A| 8RPS24030|
5 A| 8RPS24050| 5 A| 8RPS24050
10 A| 8RPS24100| 10 A| 8RPS24100
1 Ph
~ 100…120 V| 20 A| 8RPM24200| | 1 Ph
~ 200…240 V| 20 A| 8RPM24200|
2 Ph
~ 0200…500 V| 3 A| 8RPS24030| | 3 Ph
~ 380…500 V| 20 A| 8WPS24200|
5 A| 8RPS24050| 40 A| 8WPS24400
10 A| 8RPS24100
|
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION OR ARC FLASH
Disconnect all power before servicing equipment.
Failure to follow these instructions will result in death or serious
injury.
| OFF
---|---
| Green
| Orange
| Red
AUTO
Constant current mode. Return to rated power supply operation once the source
of overcurrent has been corrected.
I out|
---|---
| Iout ≤ In
| Iout > In
| 0 V / 0 A
Power deactivated after detection of overcurrent, overvoltage or
overtemperature. (1)
0V/0A
MANU
Error retention. Following deactivation, remove power to the primary circuit
and reapply power to the product again.
2 ABL 8pP max output //
SELV / TBTS
Outputs connected in parallel
SELV: Safety Extra Low Voltage
2 ABL 8pP max output …..
SELV / TBTS
Series connection of the power supplies
PELV / TBTP
PELV / TBTP :
PELV: Protection Extra Low Voltage
Paralleling:
– Use maximum of 2 power supplies of the same reference.
PELV / TBTP
WARNING
RISK OF MATERIAL DAMAGE AND HOT ENCLOSURE
– Allow the product sufficient time to cool before touching.
– Follow proper mounting instructions including torque values and the crimping
lengths on wire terminations.
– Do not allow liquids or foreign objects to enter this product.
Failure to follow this instruction can result in death, serious injury, or
equipment damage.
Environment characteristics
Installation in a pollution degree 2 environment.
Maximum surrounding air temperature 50 °C (122 °F).
Minimum temperature rating of the conductor wires connected to the terminals :
75 °C (167 °F).
Selection of the protections on the power supply primary circuit
To be ordered separately
www
.schneider-electric.com
W9 1489414 01 11 A05
07 – 2017
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>