chicco MYFIT MyFit Harness Booster Car Seat Instructions
- June 9, 2024
- chicco
Table of Contents
MYFIT MyFit Harness Booster Car Seat
Instructions
MYFIT MyFit Harness Booster Car Seat
WARNING: Avoid serious injury or death to your child. Never use your
MyFit Child Restraint without the softgoods in place. You must read and
understand the Softgood Removal instructions and the instructions in the User
Guide. If you do not understand these instructions, DO NOT attempt to remove
the softgoods, STOP and call Elfe Juvenile Products at
1-800-667-8184.
INSTRUCTIONS: MyFit Softgoods Removal/Installation
IMPORTANT: Please also refer to the instructions that came with your
product.
SOFTGOODS REMOVAL
-
Completely loosen Harness by pressing Harness Release Button on the front of the Child Restraint and pulling out on both of the Harness Straps. Then unbuckle the Chest Clip and Harness Buckle.
-
Unhook the hook and loop Tab and remove BOTH Shoulder Pads.
-
Remove the Crotch Strap Pad by pushing the fabric Tab through the slot on the BACK of the Harness Buckle. Then pull the Tab out of the FRONT and remove Crotch Strap Pad.
-
Remove BOTH of the cup holders by pressing the orange button located on the bottom edge of the Cup Holder and lifting up.
-
Thread the Crotch Strap down through the fabric and pull the FABRIC up around the front and sides of the seat.
Then pull fabric around the Harness Adjuster Strap Cover. The plastic Harness Adjuster Strap Cover is NOT removable. -
With the Headrest in the highest position, locate the elastic strap on the BACK of the Headrest and unhook by pulling up on the fabric tab. Repeat this step for the other elastic strap.
-
Pull back gently on both of the plastic tabs at the top of the Headrest and pull up on the Headrest fabric.
-
Remove the Headrest Fabric Pad, as shown.
Be careful to not damage the foam insert when removing the Headrest fabric. -
Unhook the Armrest fabric loop from the side hook located near the vehicle belt path. Repeat this step for the other side.
-
Undo the snap attaching the Armrest Fabric to the Backrest Seat Pad and then remove the Armrest Fabric. Repeat this step for the other Armrest.
-
Unhook BOTH elastic straps on the back of the Child Restraint. Pull the fabric out gently from the groove around the Child Restraint. Repeat for the other side.
-
Unhook the elastic strap from the side hook and the top hook located near the vehicle belt path. Repeat for the other side.
-
Remove the Backrest Seat Pad from the Child Restraint.
NEVER use Child Restraint without the Seat Pad.
CROTCH STRAP REMOVAL: -
Fully recline the seat (position 1). Turn the Child Restraint over and locate the crotch strap metal bar. Turn metal bar slightly and get corner to go through slot. Push metal bar through slot while pulling crotch belt out.
NEVER use Child Restraint without the Crotch Strap installed.
CROTCH STRAP INSTALLATION -
Push the metal bar through slot on top of the Child Restraint seat and pull through the other side. Turn the metal bar so that it lays flat on the bottom of the seat.
NEVER use Child Restraint without the Crotch Strap installed.
Cleaning Instructions:
Fabrics may be hand washed using mild soap and water, or machine washed in
cold water on delicate cycle using mild detergent. Hang to dry. DO NOT BLEACH.
Please consult your product manual for additional care and maintenance
instructions.
DO NOT remove the Harness Straps, Chest Clip, and Chest Clip pads. The Chest
Clip Pads can be easily spot cleaned with warm water and mild soap. Contact
Elfe Juvenile Products Customer Service at
1-800-667-8184 for assistance or
additional information.
SOFTGOODS INSTALLATION
-
Place the Backrest Seat Pad onto the Child Restraint
-
Hook the elastic strap onto the side hook and the top hook located near the vehicle belt path. Repeat for the other side.
-
Tuck the fabric into the groove gently around the Child Restraint. Repeat for the other side. Hook BOTH elastic straps onto the back of the Child Restraint.
-
Slide the Armrest Fabric onto the armrest then snap the Armrest Fabric to the Backrest Seat Pad. Repeat this step for the other Armrest.
-
Hook the Armrest fabric loop onto the side hook located near the vehicle belt path. Repeat this step for the other side.
-
Place the Headrest Fabric Pad onto the Headrest.
-
Tuck the fabric into the groove at the top of the headrest. Push down gently on both of the plastic tabs at the top of the Headrest until they snap into the grooves.
-
With the Headrest in the highest position, hook the elastic strap onto the BACK of the Headrest. Repeat this step for the other elastic strap.
-
Place the Seat Bottom Fabric onto the Child Restraint and pull fabric around the Harness Adjuster Strap Cover. Then pull the Crotch Strap UP through the fabric and pull the FABRIC down and around the front and sides of the seat.
-
Match the “R” and “L” Cup Holders to the Child Restraint, and insert the Cup Holder. Make sure the lip fits behind the groove and it clicks into place. Repeat this step for the other Cup Holder.
-
Replace the Crotch Strap Pad by sliding the Harness Buckle up through the Crotch Strap Pad. Then push the fabric Tab through the slot on the FRONT of the Harness
Buckle. Then pull the Tab out of the BACK to secure it. -
Re-attach Shoulder Pad by folding the hook and loop Tab over the Harness Strap. Secure both hook and loop sides together. Repeat for the other Shoulder Pad and make sure they are oriented, as shown.
SS0007 .A.CA.E
Documents / Resources
|
chicco MYFIT MyFit Harness Booster Car
Seat
[pdf] Instructions
MYFIT MyFit Harness Booster Car Seat, MYFIT, MyFit Harness Booster Car Seat,
Booster Car Seat, Car Seat
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>