TIDI PRODUCTS AquaGuard Sheet 7” x 7” Shower Protection Instruction Manual

TIDI PRODUCTS AquaGuard Sheet 7” x 7” Shower Protection

INSTRUCTIONS FOR USE

**Description

**

AquaGuard is an impermeable moisture barrier that allows a clinician or patient to cover wounds, dressings and intravenous sites and keep them dry when showering. It consists of an occlusive polyethylene barrier with a gentle adhesive border, and is available in a variety of sizes.

Indications for Use

AquaGuard is designed to cover and keep wounds, dressings and intravenous sites dry during showering. Common applications include PICC lines, ports, subclavian and internal jugular sites, small surgical sites, and other sites on the chest or back. This product may be applied by healthcare providers or patients.

Contraindications

AquaGuard is intended for showering only and is not recommended for swimming or submersion underwater. AquaGuard is not a replacement for primary dressings.

Precautions

For best results, a caregiver should apply the AquaGuard product to the patient. Apply AquaGuard to clean dry skin. Do not use lotion or cream before applying. Do not lift and/or attempt to reposition AquaGuard after placement. Do not use if punctured or showing signs of wear. AquaGuard is a single use product. If reused, may not provide an effective barrier while showering. If sensitivity or irritation develops, discontinue use.

Ensure proper size AquaGuard is selected prior to application. For a detailed list of available sizes and coverage areas, visit http://www.tidiproducts.com/ifu

Directions For Application

1. Prior to application, keep the skin dry and clear from oils and lotion. An alcohol wipe may be used to prepare skin for application.

2. Prepare AquaGuard for application by forming “tabs” in the backing strips at each corner. See Figure 1.

3. Using the tab, remove the top backing strip and apply the underlying adhesive to the skin. See Figure 2.
   
   ● For subclavian sites: Place the adhesive on skin above the central line or port dressing.
   ● For internal jugular sites: Place the adhesive just above the dressing following below the contour of the jaw line and if possible toward the chin.

4. Individually remove the side backing strips, pleat each side, and apply. See Figure 3.
   
   ● For subclavian sites: Remove the side strip and create a “pleat” in the middle while placing adhesive on skin. Pinch the pleat then fold side-to-side while applying pressure to ensure good adhesion. Repeat for other side.
   ● For internal jugular sites: Have patient tilt neck away from site. Remove side strip and place along side of the dressing site. If pleating is necessary, pinch the pleat then fold side-to-side while applying pressure to ensure good adhesion. Repeat for other side.

5. Remove the bottom strip and place just below dressing site, pleating if necessary. See Figure 4.
   

6. Massage adhesive border against skin to ensure seal. See Figure 5 and 6.
   
   

Directions For Removal

1. After shower, gently pat surrounding area dry before removal.
   Gently pull down in the direction of hair growth and discard.
   Note: Some dampness may occur due to perspiration.

  Tl DI Products, LLC
– 570 Enterprise Drive
Neenah, WI 54956 USA

MadeinUSA
Toll-Free: 1.800.521.1314
International: +1.920.751.4300
www.tidiproducts.com
© 2021 TIDI Products, LLC
AQUAGUARD• is a trademark ofTIDI Products, LLC, registered in the USA. Used under license.

http://www.tidiproducts.com/ifu

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>