GE current ALB091 Albeo LED Round High Bay IP65 Luminaire Installation Guide
- June 9, 2024
- GE current
Table of Contents
GE current ALB091 Albeo LED Round High Bay IP65 Luminaire
Read these instructions completely and carefully.
WARNING
RISK OF ELECTRIC SHOCK
- Turn power off before inspection, installation or removal.
- Properly ground electrical enclosure.
RISK OF FIRE
- Follow all NEC and local codes.
- Use only UL approved wire for input/output connections
Minimum size 18 AWG wire.
Save These Instructions
Use only in the manner intended by the manufacturer.
If you have any questions, contact the manufacturer at
LightingProdInfo@gecurrent.com
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAN ICES-005(B)/NMB-005(B)
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
IP rating: IP65, can be used in wet locations.
Do not use fixture in any corrosive environments. Do not operate outside rated
fixture voltage
Prepare Electrical Wiring
Electrical Requirements
- The LED luminaire must be connected to the mains supply according to its ratings on the product label.
- Class 1 wiring should be in accordance with NEC.
Grounding Instructions
- The grounding and bonding of the overall system shall be done in accordance to local electric code of the country where the luminaire is installed.
Installation Guide
-
Choose wattage and CCT by switching the switches.
-
Option: Sensor or 0-10V dimming.
Installation of sensor:
Remove the plug and install the sensor as shown in the picture. The installation of microwave sensor is of the same as PIR sensor.
Option A: Sensor usage.
Option B: 0-10V dimming remove the isolate cover on dimming wires (purple and pink).
Warning: Do not install any sensor. -
Install fixture using one of the three methods shown below.
-
Connect wires as shown below in the diagram.
-
Optional: Secure tether to the fixture.
Warning: safety tether could be only use once! -
Optional: Secure PC refractor to the fixture.
-
Optional: Secure aluminum refractor to the fixture.
-
Optional: Secure wire guard to the fixture.
www.gecurrent.com
© 2022 Current Lighting Solutions, LLC. All rights reserved. GE and the GE
monogram are trademarks of the General Electric Company and are used under
license. Information provided is subject to change without notice. All values
are design or typical values when measured under laboratory conditions.
ALB091 (Rev 5/13/22)
References
- LED Commercial Lighting and Lighting Controls | Current - GLI Brands
- Commercial Lighting and Lighting Controls | Current - GLI Brands
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>