ZEBRA ZD411D Desktop Printer User Guide
- June 9, 2024
- ZEBRA
Table of Contents
ZD411D Desktop Printer
User Guide
Setup
IMPORTANT
Go to zebra.com/setup and install the driver for
your printer.
The driver MUST be installed before connecting the printer to the computer, or it will cause complications. If your Microsoft Windows-based computer does not have the driver installed for this printer, download it from zebra.com/setup and install it before continuing.
Remove Packing
Slide the release latches (1) to the front to unlock the cover.
Open the printer and remove the packing (1).
Load Media
Unroll and discard the outer layer (1) of the media roll (2).| Spread the roll
holders (2) open and place the roll (1) into the printer.
Verify the roll spins easily on the holder.| Pull the end of the roll past the
front edge of the printer.
Press the media under the guides (1).
Adjust Sensor
Align the sensor (1) to the center of the roll for regular labels and
receipts.| Align the sensor (2) to marks (1) away from the center of the roll
for marked
labels.
Close Printer
Press down on the front edge of the printer until it locks.
Connect Power
A. Plug the power supply into the printer.
B. Plug the power cable into the power supply.| C. Plug the power cord into an
appropriate receptacle.
D. The power supply lights green.
Connect USB
A. Remove the port blocker label.
B. Connect the USB cable to the printer and your computer.
Power On
Press the power button (1).| When the the printer is ready, the printer status light (1) will turn green.
Smart Calibration
Press and hold the Pause (1) and Cancel (2) buttons for two seconds to line up the labels.
Print Configuration Report
Press and hold the Feed (1) and Cancel (2) buttons for two seconds to print a configuration report.
Support and Information
View user documentation and how-to videos.| View Quick Answers and
Knowledge Base.
---|---
|
zebra.com/zd411d-info|
zebra.com/knowledge
Need to design a label?| Join Community Connection of Zebra users and
ambassadors.
|
zebra.com/zebradesigner|
zebra.com/supportcommunity
Learn about genuine Zebra supplies.| Contact Zebra about your
printer.
|
zebra.com/supplies|
zebra.com/contact
Need to manage your printer?| Need to secure your printer?
| 
zebra.com/ppme|
zebra.com/printsecure
Media Out
When the media runs out, the printer and media status lights (1) will turn red.| Open the printer and discard the empty roll (1).
Cleaning
Clean printhead (1) with a cleaning pen (2). Clean from the middle to the outside. The cleaning pen is only for cleaning a printhead.
Zebra Technologies
3 Overlook Point
Lincolnshire, IL 60069 USA
zebra.com
ZEBRA and the stylized Zebra head are trademarks of Zebra Technologies Corp.,
registered in many jurisdictions worldwide.
All other trademarks are the property of their respective owners.
© 2022 Zebra Technologies Corp. and/or its affiliates. All rights reserved.
References
- Contact Zebra
- Zebra Support Community
- PrintSecure | Security Software | Zebra
- Zebra Support Community
- ZD411 Desktop Printer Support & Downloads | Zebra