MERCUSYS MB110-4G 300 Mbps Wireless N 4G LTE Router Installation Guide
- June 9, 2024
- MERCUSYS
Table of Contents
4G LTE Router
Quick Installation Guide
Hardware Connection
*Image may differ from actual product.
Connect the Hardware
- Insert the SIM card into the slot until you hear a click.
- Connect the power adapter to the router.
- Wait until the LED turns on. Your router is connected to the internet successfully.
Note: If the LED does not turn on (no internet), refer to FAQ-2.
Enjoy the Internet
Connect your device to the router (wired or wireless).
The default wireless network name (SSID) and password are printed on the label
at the bottom of the router.
Customize the Router
- Make sure your computer is connected to the router (wired or wireless).
- Launch a web browser and type in http://mwlogin.net. Create a password for future logins.
- Follow the Quick Setup instructions to complete the initial configuration.
Note: The router can also be used (or configured) in Wireless Router Mode for DSL/Cable connections. For more information, please refer to the user guide at https://www.mercusys.com/support/.
FAQ (Frequently Asked Questions)
What should I do if I cannot access the web management page?
– Reboot your router and try again.
– If the computer is set to a static IP address, change its settings to obtain
an IP address automatically.
– Make sure http://mwlogin.net is correctly entered in
the web browser.
– Use another web browser and try again.
– Disable and then enable the active network adapter and try again.
What should I do if I cannot access the internet?
– Verify that your SIM card is an LTE or WCDMA card.
– Verify that your SIM card is in your ISP’s service area.
– Verify that your SIM card has sufficient credit.
– Log in to the router’s web management page, and check the following:
- Go to Advanced > Network > PIN Management to verify if PIN is required. If it is, enter the correct PIN provided by your ISP.
- Go to Advanced > Network > Internet to verify the parameters provided by your ISP are correctly entered. If they are incorrect, create a profile with the correct parameters, then select the new profile from the Profile Name list.
- Go to Advanced > Network > Data Settings to verify if the used data exceeds the allowance. If it does, click Correct and set the used data to 0 (zero), or disable Data Limit.
- Go to Advanced > Network > Internet to verify that Mobile Data is enabled. If it is not, enable it to access the internet.
- Confirm with your ISP if you are in a roaming service area. If you are, go to Advanced > Network > Internet to enable Data Roaming.
How do I restore the router to its factory default settings?
– With the router powered on, press and hold the WPS/RESET button on the rear
panel until the Power LED starts blinking, then release the button.
– Log in to the router’s web management page, and go to Advanced > System
Tools > Backup & Restore to reset the router.
What should I do if I forget my wireless network password?
– The default wireless password is printed on the product label of the router.
– Connect a computer directly to the router via an Ethernet cable. Log in to
the router’s web management page and go to Basic > Wireless to retrieve or
reset your
wireless password.
MERCUSYS hereby declares that the device is in compliance with the essential
requirements and other relevant provisions of directives 2014/53/EU,
2009/125/EC, 2011/65/EU and (EU)2015/863.
The original EU declaration of conformity may be found at
https://www.mercusys.com/en/ce.
For MERCUSYS Branded Products Only. For the information about warranty period,
policy and procedures, please visit https://www.mercusys.com/en/support
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY HAVE OTHER RIGHTS
THAT VARY FROM STATE TO STATE (OR BY COUNTRY OR PROVINCE).
TO THE EXTENT ALLOWED BY LOCAL LAW, THIS WARRANTY AND THE REMEDIES SET FORTH
ARE EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES, REMEDIES AND CONDITIONS.
MERCUSYS warrants the MERCUSYS branded hardware product contained in the
original packaging against defects in materials and workmanship when used
normally in according with MERCUSYS’ s guidelines for some period which
depends on the local service from the date ooriginal retail purchase by the
end-user purchaser.
For technical support, the user guide and more information, please visit http://www.mercusys.com/en/support.
http://www.mercusys.com
© 2022 MERCUSYS 7107500246 REV1.0.0
References
- Welcome to MERCUSYS
- Support-Welcome to MERCUSYS
- Regulatory Compliance - Welcome to MERCUSYS
- Support-Welcome to MERCUSYS
- Support-Welcome to MERCUSYS
- UKCA - Welcome to MERCUSYS
- PSTI STATEMENT OF COMPLIANCE - Welcome to MERCUSYS