Tronsmart Bang Mini Portable Outdoor Party Speaker User Manual

Tronsmart Bang Mini Portable Outdoor Party Speaker

Button Configuration

HOW to use?

Bluetooth Connection

Click Tronsmart Bang Minř to Connect b. Attached to NFC Area to Connect. Only for certain. Android phones

How to Enter/Exit Stereo Pairing

• Turn on two speakers and make sure they haven’t connected with any device.
• Press ‘Stereo Pairing button once on either speaker.
• Host Speaker to enter stereo pairing mode.
• The stereo pairing indicator of the host speaker will stay white while vice one will of.
• If paired successfully, the stereo pairing indicator of the host speaker will stay white while vice one will flash white once 3s.
• Search & click Tronsmart Bang Mini to connect.
• The stereo pairing indicator of the host speaker will stay white while vice one will stay white for 5s.
• Press Stereo Pairing button once on either speaker to exit stereo pairing mode.

Package Contents

• 1x Tronsmart Bang Mini Portable Outdoor Speaker
• 1×3.5mm Audio Cable
• 1x Type C Charging Cable
• 1 x Warranty Card
• 1x User Manual
• 1x SoundPulse Card

NFC Streaming

Confirm Bluetooth & NFC functions are enabled on your device, and then put the device on the NFC area of the speaker to pair automatically.

USB A Power Bank Function

This speaker carries a USB charge-out function that will automatically detect your device and begin to charge it when the charging cable is plugged into the USB-A port under powering-on mode. Kindly note that the power bank functions for only 30 minutes if doesn’t play any sound.

Auxin Mode

Simply connect the speaker with your non Bluetooth device via the 3.5 mm audio jack cable.

Note
After plugging in an audio cable, the speaker will automatically switch to Auxin mode.

TF Card Slot Mode

The speaker will play the music from your TF/Micro SD card when plugging the card into the slot.

USB Flash Drive Mode

The speaker will play the music from your U-disk when plugging into the slot.

Auto Power Off

The speaker will power off automatically after 30 minutes if it does not pair with any device through Bluetooth or doesn’t play any sound after pairing, When on low battery or charging for a device for 30 minutes without playing sound, the speaker will power off automatically as well.

Specifications

FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions

• This device may not cause harmful interference.
• This device must accept any interference received, inducing interference that may cause undesired operation.

Note
This equipment has been tested and found to comply with the limits for a Class B digital device. pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance coudd void the user’s authority to operate the equipment. RF Warning Statement The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>