emerio FH-212092.1 Electric Fan Heater Instruction Manual
- June 4, 2024
- emerio
Table of Contents
FH-212092.1
Fan Heater
**Instruction Manual
**
This product is only suitable for well-insulated spaces or occasional use.
SAFETY INSTRUCTIONS
Before use make sure to read all of the below instructions in order to avoid
injury or damage, and to get the best results from the appliance. Make sure to
keep this manual in a safe place. If you give or transfer this appliance to
someone else make sure to also include this manual.
In case of damage caused by the user failing to follow the instructions in
this manual, the warranty will be void. The manufacturer/importer accepts no
liability for damages caused by failure to follow the manual, negligent use,
or use not in accordance with the requirements of this manual.
-
This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.
-
Children shall not play with the appliance.
-
Cleaning and user maintenance shall not be made by children without supervision.
-
Children of less than 3 years should be kept away unless continuously supervised.
-
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
-
CAUTION — Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.
-
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.
-
WARNING: In order to avoid overheating, do not cover the heater.
-
Do not use this heater in the immediate surrounding of a bath, a shower, or a swimming pool.
-
The heating appliance must not be placed just below an electrical outlet.
-
Means “DO NOT COVER “.
-
Do not use this heater if it has been dropped.
-
Do not use it if there are visible signs of damage to the heater.
-
Use this heater on a horizontal and stable surface.
-
WARNING: Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own unless constant supervision is provided.
-
WARNING: To reduce the risk of fire, keep textiles, curtains, or any other flammable material at a minimum distance of 1 m from the air outlet.
-
Before inserting the plug into the main socket, please check that the voltage and frequency comply with the specifications on the rating label.
-
If an extension cord is used it must be suited to the power consumption of the appliance, otherwise overheating of the extension cord and/or plug may occur.
There is a potential risk of injuries from tripping over the extension cord. Be careful to avoid dangerous situations. -
Disconnect the mains plug from the socket when the appliance is not in use and before cleaning.
-
Ensure that the mains cable is not hung over sharp edges and keep it away from hot objects and open flames.
-
Do not immerse the appliance or the mains plug in water or other liquids. There is a danger to life due to electric shock!
-
To remove the plug from the plug socket, pull the plug.
Do not pull the power cord. -
Do not touch the appliance if it falls into the water. Remove the plug from its socket, turn off the appliance and send it to an authorized service center for repair.
-
Do not plug or unplug the appliance from the electrical outlet with a wet hand.
-
Never attempt to open the housing of the appliance, or to repair the appliance yourself. This could cause electric shock.
-
Never leave the appliance unattended during use.
-
This appliance is not designed for commercial use.
Indoor use only. -
Do not use the appliance for other than intended use.
-
Do not wind the cord around the appliance and do not bend it.
-
Humidity, dust, hair, or other foreign objects should not enter the unit, if so there will be a danger of fire and electrical shock.
-
Don’t allow moisture and dust to enter the appliance.
Don’t use this heater in bathrooms or laundry. Store it in dry areas. -
Children must not play with or plug in the heater. Keep children away from the package. Polyethylene bags can be dangerous.
-
Do not use this appliance to dry or heat clothing, shoes, pipes, or any other items.
-
Use the appliance in well-ventilated areas only. This heater is hot when in use, to avoid burns, do not let bare skin touch the hot surfaces.
-
This heating device is not suitable for assembling vehicles and machines.
-
The rotor guard shall not be disassembled/opened to clean the rotor blades.
-
To avoid the risk of fire or electric shock do not remove the housing.
PARTS DESCRIPTION
- Control panel and LED display
- Air outlet
- Base
- Compartment for remote control & remote control
- Handle
- Air inlet
- Main power switch
- On/Standby button
- Temperature / time (+)
- Temperature / time (-)
- Timer button
- Horizontal rotation button
- Mode button
Remote control
Please use one piece of CR2025 battery for this remote control. Please insert
the battery to the remote control tightly (Refer to the instruction behind the
remote control). If it is not in use for a long time, please take the battery
out of the remote control. Keep button cell batteries out of reach of small
children.
Note!
There might be a small amount of smoke and odor when first-time use. This is
not harmful and will stop after a short while. Please ensure meanwhile that
there is sufficient ventilation.
Operation
Plug the appliance into an appropriate electrical outlet. Turn on the appliance by pressing the main power switch to position “I”. A beep sound will be heard and in the meantime, “…” shows on the LED display. Press the button “ ”, and the appliance begins to work. Room temperature and power icon “Lo” (low heat output) will alternatively appear on the display.
-
Power setting
Press the button “Mode” to set high heat mode (2000W) or low heat mode (1000W), and the display of “HI” (high) or “Lo” (low) will be on the display accordingly. -
Temperature setting
Press the button “-” or “+” to set the desired temperature. You can choose from 6℃ to 35℃. When you set your desired temperature, it will flash a few seconds, and then shows the room temperature again.
When you set your desired temperature, the appliance starts to heat when the room temperature is 2℃ below the set temperature and will stop heating as soon as the set temperature is reached. -
Timer setting
Press button “ ”, “0H” will flash on the display, press button “+” or “-” to set your desired working hour from 1h to 24h. The set working time will flash several times, and then the room temperature will show and a little dot will flash on the display. The timer setting is done. The appliance will shut itself off automatically when the time is up.
Press the button “ ”, and set the working hour to “0H” to cancel the timer setting.
If do not set the timer, the appliance will be shut down automatically after 12 hours of continuous work. -
Horizontal rotation function
Press the button “ ”, and the appliance begins to rotate. Press the button “ ” again, and the rotation will stop. If the horizontal rotation function is on when the room temperature reaches the set temperature and the appliance stops heating, the rotation will stop too; it will start again when the appliance starts to heat.
Always switch off the horizontal rotation function before you switch off the appliance. -
Turn off
Press the button “ ” again to turn off the appliance. The fan will continue to work for another 20 seconds (the display will show a countdown from 20 to 0) to protect and enhance the lifespan of the product. Turn off the main power switch and unplug the power cord from the outlet.
SAFETY SYSTEM
- The appliance has a safety system that automatically switches off the unit when overheated.
- If overheating occurs, switch off the appliance, remove the plug from the socket, and let it cool down for at least 30 minutes. Put the plug in the socket and switch on the heater.
- This heater is equipped with a tilt protection safety device. For safety reasons, the unit will automatically switch off the power after the 20s later if it is put on unstable or uneven surfaces or if it is tilted accidentally.
MAINTENANCE
- The fan heater only needs regular cleaning on the outside.
- Before you clean the unit, turn off the switch. Remove the plug from the socket and wait until the fan heater cools down completely.
- Use a damp cloth to wipe the heater housing and use a vacuum cleaner or a dusting brush to clean the air inlet grille and outlet grille.
- Do not use detergents, abrasive cleaning liquids, or chemicals (alcohol, gasoline, etc.) to clean the appliance.
- Never immerse the appliance in the water!
- If the appliance is not used for an extended period it must be protected against excessive dust and dirt.
Please store it in a dry place away from sunlight and dirt.
TECHNICAL DATA
Operating voltage: 220-240V ~ 50Hz
Power consumption: 2000W
GUARANTEE AND CUSTOMER SERVICE
Before delivery, our devices are subjected to rigorous quality control. If,
despite all care, the damage has occurred during production or transportation,
please return the device to your dealer. In addition to statutory legal
rights, the purchaser has an option to claim under the terms of the following
guarantee:
For the purchased device we provide 2 years guarantee, commencing from the day
of sale. If you have a defective product, you can directly go back to the
point of purchase.
Defects that arise due to improper handling of the device and malfunctions due
to interventions and repairs by third parties or the fitting of non-original
parts are not covered by this guarantee. Always keep your receipt, without the
receipt you can’t claim any form of warranty. Damage caused by not following
the instruction manual will lead to a void of warranty, if this results in
consequential damages then we will not be liable. Neither can we hold
responsible for material damage or personal injury caused by improper use if
the instruction manual is not properly executed? Damage to accessories does
not mean free replacement of the whole appliance. In such case please contact
our service department. Broken glass or the breakage of plastic parts is
always subject to a charge. Defects to consumables or parts subjected to
wearing, as well as cleaning, maintenance, replacement of said parts, or
shipping and transportation costs to and from any place of repair are not
covered by the warranty and are to be paid.
ENVIRONMENT-FRIENDLY DISPOSAL
Recycling – European Directive 2012/19/EU
This marking indicates that this product should not be disposed of with other
household wastes. To prevent possible harm to the environment or human health
from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used device, please
use the return and collection systems or contact the retailer where the
product was purchased. They can take this product for environmentally safe
recycling.
BATTERY MUST BE RECYCLED OR DISPOSED OF PROPERLY. DO NOT OPEN. DO NOT
DISPOSE OF IT IN FIRE OR SHORT CIRCUIT.
Emerio Switzerland AG
Oberneuhofstrasse 1
6340 Baar
Switzerland
ERP information
Declare that the product detailed below:
Information requirements for electric local space heaters
Model identifier(s):
Item| Symbol| Value| Unit| Item| I Unit
Heat output| | | | Type of heat input, for electric storage local space
heaters only (select one)
Nominal heat output| Priom| 2.| kW| manual heat charge control, with
integrated thermostat| N/A
Minimum heat output
(indicative)| Pmin| 0.986| kW| manual heat charge control with room and/or
outdoor temperature feedback| N/A
Maximum continuous heat output| Pmax,c| 2.| kW| electronic heat charge control
with room and/or outdoor temperature feedback| N/A
Auxiliary electricity consumption| | | | fan-assisted heat output| N/A
At nominal heat output| elmax| N/A| kW| Type of heat output/room temperature
control (select one)
At minimum heat output| elmin| N/A| kW| single stage heat output and no room
temperature control| [no]
In standby mode| else| 0.21| kW| Two or more manual stages, no room
temperature control| [no]
| | | | with mechanic thermostat room temperature control| [no]
| | | | with electronic room temperature control| [yes]
| | | | electronic room temperature control plus day timer| [no]
| | | | electronic room temperature control plus week timer| [no]
| | | | Other control options (multiple selections possible)
| | | | room temperature control, with presence detection| [no]
| | | | room temperature control, with open window detection| [no]
| | | | with distance control option| [no]
---|---|---|---|---|---
| | | | with adaptive start control| [no]
| | | | with working time limitation| [yes]
| | | | with black bulb sensor| [no]
Contact details| Emerio Switzerland AG Oberneuhofstrasse 1 6340 Baar
Switzerland
Satisfies the requirement of the Council Directives:
COMMISSION REGULATION (EU) No 2015/1188 of 28 April 2015 and Amending
COMMISSION REGULATION (EU) 2016/2282 implementing Directive 2009/125/EC of the
European Parliament and of the Council with regard to ecodesign requirements
for local space heaters
Regarding information for consumers on how to install, use and maintain the
product, WEEE information, please check the instruction manual provided with
the packaging.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>