FS S3200 Series Switches Enable Web Management User Guide
- June 9, 2024
- FS
Table of Contents
FS S3200 Series Switches Enable Web Management
Introduction
This document details the steps to upgrade the switch system firmware for version 1.0.1.11
Topology
3. Configuration Steps
Connection Equipment
According to the way of networking topo to connect PC and S3200-8MG4S switch
to network.One end of the RJ-45 cable is connected to the PC’s network port,
and the other end is connected to the Manage interface of S3200-8MG4S. At the
same time, one end of console line USB is connected to PC’s USB interface, and
the other end of RJ-45 connector is connected to console interface of front
panel of switch.
Download Related Software
Search and install SecureCRT debugging software and Tftpd32 file transfer
software through Google.
Configure Computer Ip
Before connecting to the device, we need to configure the IP of the local
computer, so that the computer ip and the switch ip are in the same network
segment.
- First Step： Open the Network and internet configuration,and select ‘Change adapter options’
- Second step: Double-click ‘Ethernet’ –> Select’ Properties’ –> Double-click ‘Internet Protocol Version 4 (TCP / IPV4)’ — > select ‘Use the following IP address ’,Modify the ip address and save.
Note that the default ip for the switch is 192.168.1.1
Configure Software Parameters
After the switch is powered on, right-click “My Computer” on the PC, click
Manage, and check the com port corresponding to the console line in the device
manager. (If an unrecognized USB device is displayed, please download and
install the corresponding driver), then open SecureCRT, select the serial port
login method, and select the serial number from the device manager. The baud
rate is 115200 and flow control is not selected. As the picture shows.
Login Switch
When starting the switch, and display “Hit Esc key to stop autoboot: 1”, press
“ESC” button to enter the command line. As the picture shows
Configure the Port of the Network Card Connection Device for the Server
After completing the previous step, we need to configure the port of the
server network card connection device.
For example: the network card connection port 1 of the server.
Enter the command to initialize port 1
RTL9310# rtk network on
RTL9310# rtk macsds set 2 sgmii
Configure Tftpd32 Software
Open Tftpd32 software and set Server interfaces as the local IP address of the
computer. Current directory file Select the location where the firmware file
is stored.As the picture shows.
Upgrade the System Firmware
Upload the firmware file to the switch for upgrade with the following
commands:
RTL9310# upgrade image 192.168.1.88:S3200-Series-Switch-
FSOS-v1.0.1.11-Release(221128).bix
Note: 192.168.1.88 is the native ipv4 address; and S3200-Series-Switch-
FSOS-v1.0.1.11-Release(221128).bix is the firmware file
Restart the Device
After all the above steps, we need to restart the device to upgrade
successfully. The restart command is as follows:
RTL9310# reset
Enter Web Interface
After the restart,Upgrade completed.Enter the Administrator IP address:192.
168. 1.88 in the URL bar of Google Browser,then enter the default username and
password admin/admin.As the picture shows
The information in this document is subject to change without notice. FS has made all efforts to ensure the accuracy of the information, but all information in this document does not constitute any kind of warranty.
Copyrighto 2009-2022 FS.COM All Rights Reserved.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>