RAWLINK 36101 Bicycle Trailer Instruction Manual

Model 36101
Instruction manual
BIKE TRAILER 

Introduction

To get the most out of your new bike trailer, please read through these instructions before use. Please also save the instructions in case you need to refer to them at a later date.

Technical data

Special safety instructions

It is forbidden to cycle with children in the bike trailer!
A bike must have two or more brakes if ridden with the bike trailer.
A rear light must be attached to the bike trailer during lighting-up hours. The rear light must be attached to the centre or the left side of the bike trailer.
Always comply with traffic regulations, be alert and show due consideration when cycling. Be especially aware that a bike requires more space and manoeuvres diff erently when the bike trailer is attached.
Adapt your speed to the conditions and be aware that the braking distance is greater when towing the bike trailer.
Inspect the bike trailer and ball coupling between the bike and bike trailer before each use!
Check regularly that the wheels rotate easily and that they are not buckled and cannot rock from side to side in the hub.
Check the tyres and tyre pressure regularly.
The tyre pressure should be 30 psi.
Do not use the bike trailer if the tyres are perished, worn or defeated.
Do not use the bike trailer if it is defective or if you suspect that it is defective. If necessary, get it checked by an expert.

Main components

Assembly

1. Attach the wheels (7) to the frame (3) using the wheel axle sets (11).
   

2. Check that the washers are fitted correctly. Tighten the wheels.
   

3. Screw the reflectors (4, 6, 8) securely to the bike trailer.
   

4. Attach the pull bar (2) to the handle (12) with 1 set of M6X55 mm screw set (9), attach the handle (12) to the frame (3) using 2 sets of M6X35 mm screw set (10) and 1 set of M6X55 mm screw set (9).
   

5. Insert the box (5) into the frame (3).
   

6. The bike trailer is now assembled.

Attaching the ball coupling

Screw the holder and bracket with the ball securely to the saddle post clasp using a bolt, washer and nut.
Attach the bike trailer’s coupling to the ball and lock it tight.

• NB! It may be necessary to change to the saddle post clasp or bolt, depending on the bike type and model.

Service centre

Note: Please quote the product model number in connection with all inquiries.
The model number is shown on the front of this manual and on the product rating plate. For:

• Complaints
• Replacements parts
• Returns
• Guarantee issues
• www.schou.com

Manufactured in P.R.C.
Manufacturer:
Schou Company A/S
Nordager 31
DK-6000 Kolding

All rights reserved. The content of this manual may not be reproduced, either in full or in part, in any way by electronic or mechanical means, e.g. photocopying or publication, translated or saved in an information storage and retrieval system without written permission from Schou Company A/S.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>