Topmaq pomi2300 Electric Engraver User Manual
- June 9, 2024
- TOPMAQ
Table of Contents
Operator’s manual
pomi2300 Electric Engraver
- On/off switch
- Engraving tip
- Stroke adjustment dial
- Tip release screw
- Power cord
CAUTION
Thoroughly read and understand all instructions before using this product.
S2: 30 min.; Indicates operating time at no more than 30 minutes at rated load
followed by a complete cool down of the tool.
Specifications
Input power: 13W
Power supply: 230V ~50 Hz
Engraving bit: Tungsten Carbide Tipped steel
Installing an engraver tip
WARNING. Disconnect the engraver from the power supply before making any adjustments or maintenance procedures.
- Loosen the tip release screw (4) by turning it anticlockwise with a flat head screwdriver.
- To fit the new engraving tip (2), insert the tip through the centre of the hole of the engraver, ensuring the tip fully enters the housing. A new tip should protrude from the end of the housing by approximately 8.5mm.
- Tighten the tip release screw (4) fully by rotating in a clockwise direction.
Operation
WARNING. Always wear safety glasses when using this tool. The engraver can be used to permanently mark metal, glass, plastic, wood, ceramics and much more.
- Before using the engraver you must ensure there is an engraving tip installed.
- Connect the engraver plug to the power supply and while holding the engraver firmly, push up on the on/off switch (1) with your thumb. NOTE. To turn the tool on, press the small On/Off Switch (1) upwards to the (I) position. To turn the tool off, push the on/off Switch (1) down to the (O) position.
- Hold the engraver at an angle, like you would hold a pen. Do not press down hard while engraving, use light pressure while guiding the point over the work to be completed.
Adjusting the depth of engraving
- The stroke adjustment dial (3) located on the side of the engraver controls the stroke length and therefore the depth of engraving.
- For a fine mark turn the stroke adjustment dial (3) anti-clockwise to position `1′.
- For a deeper, thicker mark turn the stroke adjustment dial (3) clockwise to position `5′
NOTE. It is recommended that you practice on scrap material before you start.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>