evolur Wall Stud Safety Bracket Instruction Manual
- June 8, 2024
- evolur
Table of Contents
evolur Wall Stud Safety Bracket
PARTS ENCLOSED
IMPORTANT: Tipping furniture can injure young children.Use of this safety bracket hardware is highly recommended. This safety hardware, when properly installed, can provide further protection against unexpected accidental tipping of furniture due to improper use.
Step 1
- Attach a bracket to the wall board with the 1-1/2″ wood screws provided:
- It is recommended that you locate a wall stud behind the furniture unit. If a wall stud is not used, a suitable “Hollow-Wall Anchor Bolt (not provided) should be used in lieu of the wall stud.
- Position the wall bracket on the stud about 1″ below the top the furniture piece.
- Mark the position for the bracket placement on the wall and drill a pilot hole into the stud.
- Attach the bracket to the wallboard with the 1-1/2″ screws provided.
Step 2
To attach a bracket to the Furniture Frame below the top with the short screws
provided:
-
Move the furniture piece temporarily to its final position to the wall.
-
Mark the location of the bracket on the back of the furniture in relation to the previously mounted wall bracket.
-
Move the furniture piece away from thee wall mounted bracket and place the other bracket on the mark position on the back of the furniture piece.
-
Drill a pilot hole as shown in the figure or into the back furniture frame,
Caution: Make sure you do not drill completely through the back of the furniture. -
Attach the bracket to the back of the furniture with the 3/4″ screws provided.
Step 3
To Attach the safety strap:
- Move the furniture back to its final position.
- Thread the safety strap through both of the mounted brackets as shown in the illustration.
- Tighten the strap until snug.
- Do not Over tighten.
- Important: Make sure the brackets are firmly attached to the wall stud and furniture frame and the safety strap is snug.
- Warning: This product is not to be a substitute for proper parental supervision which is the only proper deterrent to prevent improper use of this unit. The manufacturer assumes no liability for improper installation or excessive loads placed on the safety straps, bracket or mounting screws. This hardware will not insure against tipping.
- Note: For taller or heavier pieces of furniture, two safety brackets may be installed.
1532 S. WASHINGTON AVE, PISCATAWAY, NJ 08854,
E-mail: info@evolurbaby.com
www.evolurbaby.com
Enter our monthly giveaway!
Simply scan the QRcode to register.
Chat with us!
For any questions or concerns or feedback.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>