TOPMAQ MF206N Blade Grinding Machine User Manual

BLADE GRINDING MACHINE USING MANUAL

MF206N Blade Grinding Machine

This machine is designed for grinding of straight blade or other kind of blade in woodworking. Called the necessary equipment for woodworking industry, it is characterized of operating conveniently and high capacity.

Preparation

1. Check the main engine and spare parts when you open the packing case. If there is something wrong, let the seller know.
2. The sliding parts are separated before the machine leaving the factory.
3. Mount the water box and pipe with the main engine.
4. Connect the electric and earthed it dependable according to the machine’s requirement.

Safety rules

1. Check the sandwheel to see if there is something wrong
2. Tighten the sandwheel screw as possible but not too tight to prevent the sandwheel crashed
3. Mount the sandwheel guard steadily.
4. Earth the machine properly.
5. The voltage and frequency must be matching with the machine
6. Turn the machine off and un-plug the cord from the power source before change the sandwheel or maintenance
7. Activate the switch for a fraction of a second and check the sandwheel rotation direction. Should rotation be incorrect, immediately switch off the power and invert two of the three phases on the terminals.
8. During the operation, press the blade solidly.
9. Wear dust mask to protect your eyes.

Operation rules

1. Do the safety work well before connect with the mains. Try to start the machine before the general operation.
2. Operation step
3. Mount the blade under the presser and fixed well before start the sandwheel.
4. Turn the infeed handwheel slightly to make the blade near the sandwheel transversely.
5. Pull out the sliding parts longitudinally to make the blade separate to sandwheel, then turn the infeed handwheel about 0.1mm( that’s the grinding capacity, pay attention to the grinding capacity)
6. After the first time grinding, dismount the blade to check the quality, then adjust the locating plate or angle knob to process the second time grinding.
7. Grinding the blade separately. No spark before the infeeding. After the grinding, finish the blade with oil stone.
8. During the operation, drop the cool liquid on the blade
9. After operation, clear the cool liquid to prevent the blade damage. If the machine is not used for a long time, spray anti-rust oil. 3.6 Lubricate the sliding part and turning part of machine.

Specifications:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>