STERLING 72261100-0 Accord 37.25-in W x 48-Inch L with Center Drain Single Threshold Rectangle Shower Base Instruction Manual
- June 8, 2024
- STERLING
Table of Contents
Installation Instructions
Watch this installation online; visit the product page at
www.sterlingplumbing.com.
72261100-0 Accord 37.25-in W x 48-Inch L with Center Drain Single
Threshold Rectangle Shower Base
Optional
- Mortar cement
- Shims
- Furring Strips
- Drop cloth
Record your model number below for future reference:
Observe all local building and plumbing codes.
Install on an adequately supported subfloor.
If the subfloor is not level and access to shim is difficult, install with a
1″ (25 mm) to 2″ (51 mm) bed of mortar cement.
1. Construct a plumb stud pocket according to the roughing-in information on
the back page.| 2. Install the rough plumbing.| 3. Install the drain to the
shower base.
---|---|---
| |
4. Staple the felt pad, if provided, to the subfloor so it will contact all
support feet.| 5. Without a pad, we recommend the basin area be set in 1″ (25
mm) to 2″ (51 mm) of mortar cement.| 6. Lift and position the shower base in
the stud pocket.
| |
7. With the unit level, shim under the support feet as needed.| 8. Install
plastic attachment clips at all stud locations.| 9. Connect the drain to the
drain pipe. Position a protective liner in the basin.
| |
10. To pre-fit the walls, remove the retaining clips. Reinstall the retaining
clips before continuing.| 11. Install the back wall. Insert the back wall
tabs into the slots.| 12. Measure, mark, and drill the faucet holes in the
drain end wall.
| |
13. Install the end walls. Engage the interlocks, pivot and snap the end
walls into the retaining clips.| 14. The front edges should be flush, with no
more than a 1/32″ (1 mm) gap.| 15. Starting at the bottom, install screws
through the dimples to secure the flanges to the studs.
| |
16. Secure the walls to the studs along the top. Use shims as needed.| 17.
Cover the framing with water-resistant wallboard. Install the finished wall
material.| 18. Install the faucet trim and accessories, and seal where they
contact the wall panels.
| |
19. After painting, apply 100% silicone sealant where the unit contacts the
finished wall.| |
| |
Roughing-In, 7224, 7225, 7226, 7227 Series
| Series | 72240100 | 72250100 | 72260100 | 72270100 |
|---|---|---|---|---|
| A | 36″ (914 mm) | 42″ (1067 mm) | 48″(1219 mm) | 60″ (1524 mm) |
| B | 18″ (457 mm) | 21″ (533 mm) | 24″ (610 mm) | 30″ (762 mm) |
| C | 10″ (254 mm) | 13″ (330 mm) | 16″ (406 mm) | 16″ (406 mm) |
| D | 16″ (406 mm) | 16″ (406 mm) | 16″ (406 mm) | 14″ (356 mm) |
Need help? Contact the Customer Care Center.
USA/Canada: 1-800-STERLING
(1-800-783-7546),
Mexico: 001-877-680-1310
For service parts information, visit
sterlingplumbing.com/parts.
For care and cleaning, visit sterlingplumbing.com/care-and-
cleaning.
Patents: kohlercompany.com/patents
This product is covered under the STERLING® Vikrell® or Acrylic Baths and
Shower Bases Ten-Year Limited
Warranty, found at
sterlingplumbing.com/warranty. For a
hardcopy of warranty terms, contact the Customer Care Center.
USA/Canada: 1-800-STERLING
(1-800-783-7546)
Mexico: 001-877-680-1310
www.SterlingPlumbing.com
1485063-2-B
© 2021 Kohler Co.
References
- Care & Cleaning Tips for Kitchen & Bathroom | Sterling Plumbing
- Find Service & Replacement Parts | Sterling Plumbing
- View Warranty Info | Sterling Plumbing
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>