KCL 743 Nitrile Disposable Glove Instruction Manual
- June 8, 2024
- KCL
Table of Contents
by Honeywell
KCL-Informationsbroschüre
Kat. III Art. 743
VIICNIT743 B26
KCL 743 Nitrile Disposable Glove
Information brochure to Section 1.4 of Annex II to Directive 89/686/EEC for personal protective equipment in Category III
The CE marking on this glove means that it meets the essential requirements
for in the European Directive EEC 89/686 concerning Individual Protection
Equipment (IPE): Harmlessness-Comfort-Dexterity-Sturdiness.
Protective Gloves conform to the EN 420. Approved to EN 374 and EN 388
according to Article 10 of Directive 89/686/EEC: IFA, Alte Heerstraße 111,
D-53757 St. Augustin, Identification number: 0121
Surveillance after 11 B of Directive 89/686/EEC, chemical risks according to
EN 374: same location as type test.
The identification number for testing and certification centre 0121 for EC
type testing and monitoring of quality assurance measures relates solely to
the content of EN374-1: 2003 and the PPE Directive 89/686/EEC.
EN 374, Full-protection protective gloves against chemicals
The protective index refers to the permeation time determined during
uninterrupted contact with the test chemical under stable laboratory
conditions. EN 374-3 = Permeation. A glove is resistant to chemicals,
when a protection index is achieved at least Level 2 in three of the chemicals
listed below. The chemicals which have passed the test are marked on the
gloves with the letters A-L. (KB=classification letters.)
EN 374, Protection against bacteriological contamination
KCL chemical protective gloves have been penetration-tested to the highest
performance level (3) set out in
EN 374-2. This quality limit equates to an AQL < 0.65.
| Penetration time in min. | Protection index |
|---|---|
| > 10 | 1 |
| > 30 | 2 |
| > 60 | 3 |
| > 120 | 4 |
| > 240 | 5 |
| > 480 | 6 |
| Article | Name |
/ Protection index**
---|---|---|---|---
743| Dermatril® P 743| 6, 7, 8, 9, 10, 11| 000X| J/2| K/6| L/2
EN 388, Mechanical risks
1st digit Abrasion resistance
2nd digit Cut resistance
3rd digit Tear strength resistance
4th digit Puncture resistance
X = Cannot be tested| (min. 0; max. 4)
(min. 0; max. 5)
(min. 0; max. 4)
(min. 0; max. 4)
---|---
KB| Chemical| CAS no.
---|---|---
J| n-Heptane| 142-82-5
K| Sodium hydroxide 40 %| 1310-73-2
L| Sulphuric acid 96 %| 7664-93-9
Gloves conform to Regulation (EC) No 1935/2004. Approved for short-term,
direct contact with all food types.
WARNING !
Resistance to the chemicals listed was determined under laboratory conditions
and may be adversely affected by changes to physical properties such as
temperature, abrasion, stretching, etc.
When using highly corrosive chemicals, degradation is the most important
factor in the choice of protective gloves.
These protective gloves provide no protection against extreme cold (<- 5 °C),
heat (> 50 °C), electricity.
Do not use in the vicinity of moving machine parts. Risk of being drawn into
the machine.
Unusable when the gloves are cracked, porous and stiff.
Allergy Notice : The Gloves may contain traces of dithiocarbamates.
Use: The protective gloves you wear must be of the correct size.
Note that using undergloves may result in some usage restrictions. Check the
protective gloves for damage before you use them. Prevent the penetration of
pollutants over the edge of the glove. Prevent carryover of contaminants
located on the glove and the cross-contamination when removing gloves.
Cleaning: The specified gloves are not washable. Do not use any chemicals
or sharp implements when cleaning (wire brushes, sandpaper, etc.). Dirt brush
off.
Expiry date: With proper storage, no reduction in performance levels
within 36 months.
Storage /Transport: Flat, dry, dark, with no additional weight load in
its original packaging, at a temperature of 5 °C – 25 °C. Protect from
sunlight and ozone.
Disposal: If not contaminated with chemicals, gloves can be disposed of
in the household waste. If the gloves have been exposed to chemicals, follow
the disposal instructions of the manufacturer of the chemicals.
For further information please contact.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>