BOSCH BCM8450UC Built-in Coffee Machine Instruction Manual
- June 8, 2024
- Bosch
Table of Contents
BOSCH BCM8450UC Built-in Coffee Machine
Safety Definitions
WARNING
This indicates that death or serious injuries may occur as a result of non- observance of this warning.
NOTICE:
This indicates that damage to the appliance or property may occur as a result
of non-compliance with this advisory.
CAUTION
This indicates that minor or moderate injuries may occur as a result of non- observance of this warning.
Note:
This alerts you to important information and/or tips.
IMPORTANT SAFETY PRECAUTIONS READ AND SAVE THESE INSTRUCTIONS
WARNING
When using electrical appliances, basic safety precautions should always be followed, including the following:
- Please read and follow the operating instructions carefully and keep them for later reference.
- If the unit is transferred, please ensure that this manual is included.
- Please read and pay particular attention to the safety information in the instruction manual.
STATE OF CALIFORNIA PROPOSITION 65 WARNING:
WARNING
Cancer and reproductive harm – www.P65Warnings.ca.gov
IMPORTANT
This appliance is designed for domestic and not commercial use.
Use indoors at room temperature only.
NOTICE:
Protect your Coffeemaker and hoses against freezing or it will be damaged.
Supervise children to ensure that they do not play with the appliance.
WARNING
To reduce risk of fire and electric shock: Installation
- Do not mount any appliance with fixed water connection over the fully automatic coffee machine.
- Connect and operate the appliance only according to the rating plate specifications.
- Use appliance only with transformer which is identified as Type 8001010566.
- Do not connect the appliance to or operate it by means of a time switch or remote control socket.
- The unit must not be operated with an extension cord.
- Use the Coffeemaker only if power cord and appliance show no signs of damage.
- Should a problem occur, pull the plug and disconnect from the power immediately.
- Never immerse the appliance or power cable in water or any liquid.
Grounding
This appliance may only be connected to a power supply with 120 Volt AC via a correctly installed receptacle with ground.
Repairs
- To avoid potential hazards, repairs must only be carried out by authorized service personnel.
- If the power cord of this appliance is damaged, it must be replaced by a original replacement power cord, which can be purchased from our Customer Service Department.
- Only an appliance which has been correctly installed according to these installation instructions can be used safely.
WARNING
To reduce risk of fire and electric shock:
- This appliance is intended for installation in permanently installed cabinetry.
- Do not install in the same cabinet with other appliances.
- Do not install in cabinets that are not securely fixed to a support structure. Attach loose furniture to the wall with a conventional bracket.
- Do not install directly above a cabinet drawer. This appliance must always be enclosed in its own cabinetry unless specified otherwise.
- Do not place any heating or cooking appliance beneath the appliance.
- Do not mount the appliance directly over or under or on side of a heating appliance. This appliance must always be enclosed in its own cabinetry unless specified otherwise.
- Do not mount over a sink.
- Directly mount cabinetry above the appliance. This appliance must always be enclosed in its own cabinetry unless specified otherwise.
- Do not store anything directly on top of the appliance surface when the appliance is in operation.
- The appliance can be installed in combination with approved products. Do not install in the same cutout with unapproved combinations.
CAUTION
To avoid the risk of suffocation:
Do not allow children to play with packaging material. Store small parts
safely as they can be a choke hazard.
To avoid the risk of injury:
Do not reach into the grinding unit. Be careful not to close the door on your
fingers. This can result in injury.
Unpacking and Moving the Coffeemaker
The unit is heavy and should be handled accordingly. Proper safety equipment
such as gloves and adequate manpower of at least two people must be used in
moving the coffeemaker to avoid injury and to avoid damage to the unit or the
floor. Rings, watches, and any other loose items that may damage the unit or
otherwise might become entangled with the unit should be removed.
Hidden surfaces may have sharp edges. Use caution when reaching behind or
under appliance.
To avoid the risk of effecting electronic implants: Hazard due to
magnetism
The appliance contains permanent magnets which may affect electronic implants,
e.g. heart pacemakers or insulin pumps. Persons wearing electronic implants
must maintain a minimum distance of 4″ (10 cm) from the appliance and from the
following parts upon removal: milk container, milk system, water tank and
brewing unit.
*Note: Unit may be installed above Bosch Warming Drawer (Model HWD5051UC, when installed with Bosch 30″ Trim Kit (Model HEZCMT3050).
Included in delivery
Fully automatic coffee machine
Installation instructions
Assembly bracket
Transformer mount
Spacers
7 fastening screws (silver)
2 fastening screws (long/black)
1 sleeve (black)
2 fastening screws (short/black)
2 sleeves (white)
Transformer
Prepare built-in units
Important: The power outlet must be located outside the built-in cut-out.
Make sure there is adequate aeration. To do this, remove the rear panel or cut
out an opening of 1911⁄16″ x 153 ⁄4″ (500 x 400 mm). There must be a gap of at
least 13 ⁄8″ (35 mm) between the wall and base of the unit or the rear panel
of the unit situated above. The ventilation slots and intake openings must not
be covered. Also follow the installation instructions for the appliance
situated above or below. If installing the appliance above a warming drawer,
the height of the recess must be 231 ⁄4″ (590 mm). If the appliance is
installed directly under a décor panel, ensure that there is a ventilation
slot of at least 31 square inches (200 cm2 ). The ideal installation height
for the fully automatic coffee machine, measured from the floor to the lower
edge of the appliance, is 377 ⁄16″ (950 mm).
Protect your Coffeemaker against freezing or it will be damaged.
CAUTION
Installation must always be performed by 2 persons.
Installation preparation
-
Unpack all the parts and check for any damage in transit. Do not operate a damaged appliance.
-
Take note of the installation dimensions of the particular model.
Important: Two openings angles can be selected for the door. Depending on the opening angle required, the mounting distance to the wall should be observed before installation.
● Opening angle approx. 110° (delivery status) = mounting distance to the wall at least 133 ⁄4″ (350 mm).
● Opening angle approx. 155° = mounting distance to the wall at least 259 ⁄16″ (650 mm).
For an opening angle of 155°, remove both the restrictors at the top and bottom of the hinge. -
Remove the installation template on the back of the installation instructions. Place the installation template at the front edge of the unit and screw on the assembly bracket c as shown with two fastening screws f. The assembly bracket must be positioned at the base of the unit and the wall such that no gap is present.
-
Fasten the the transformer mount d with two screws f in the middle.
-
Insert the transformer in the mount. The connections to both lines must point to the left.
Note: When positioning the transformer k and pushing in the appliance, do not trap the lines.
The transformer k is not allowed to touch the appliance and the back wall of the cupboard. -
Set the mains switch U to h on the appliance.
-
Securely insert the front line into the appliance (snaps into place). For this purpose, put the appliance to be plugged in just on to the edge of the unit. Plug the power cord into the socket. Plug transformer into dedicated receptacle in an accessible cabinet adjacent to the coffee maker (depends on the built-in situation). Do not plug into a receptacle behind the appliance.
-
Push the appliance into the unit until it clicks into place. Check that the appliance is in the middle. If necessary, align the appliance. To do so, pull the appliance out a little, remove the appropriate spacers e and attach to the left side (top and bottom). Push the appliance into the unit until it clicks into place.
-
Take hold of the appliance door on the right next to the outlet and open. Remove the drip tray Y. Pull the cover X on the bottom left-hand side forwards and remove. Pull out the accessories drawer Z and put to one side.
-
First, screw on the appliance as shown using 2 of each of the fastening screws f and g as well as 2 sleeves j. Then screw tight at the top right of the unit using 1 fastening screw f and sleeve h.
-
Only for the expert
In very few cases, the door of the fitted fully automatic machine can jam due to a warpage in the built-in units. The door can be adjusted. To do this adjust the hinges at the top and the bottom.
I. Adjust the depth of the door by turning the screws V.
II. Turn the screws W to adjust the inclination and the horizontal position of the doors.
-
Insert the cover X and fix with the two black fastening screws i.
-
Replace the drip tray Y and accessories drawer Z and close the appliance door.
Removal
- Undo all screws.
- Slightly pull out the appliance.
- Remove the power cord from the socket.
- Disconnect the appliance from the transformer.
- Fully remove the appliance.
Technical specifications
Power connection with transformer type 8001010566 (voltage – frequency)| 120 V
AC – 60 Hz
---|---
Power rating| 1600 W
Maximum static pump pressure| 19 bar
Maximum water tank capacity (without filter)| 81.15 oz (2.4 l)
Maximum capacity of the coffee bean container| 1 lb (17 oz)
Length of power cable (Power socket – transformer)| 39″ (1 m)
Dimensions (appliance without transformer) H x B x D| 17 7⁄8″ x 23 3⁄8″ x 14
3⁄4″
(455 x 594 x 375 mm)
Weight, empty (appliance without transformer)| 42-44 lb (19-20 kg)
Dimensions (only transformer) H x B x D| 8 1⁄4″ x 6 3⁄4″ x 6 3⁄4″
(210 x 172 x 198 mm)
Weight (only transformer)| 27.55 lb (12.5 kg)
Type of grinding unit| Ceramic
Customer Support
This Bosch Appliance is made by
BSH Home Appliances Corporation
1901 Main Street, Suite 600
Irvine, CA 92614, USA
Questions? 1-800-944-2904
www.bosch-home.com/us
We look forward to hearing from you.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>