RM ITALY KL 505V Broad Band Linear Amplifier Instructions
- June 8, 2024
- RM ITALY
Table of Contents
RM ITALY KL 505V Broad Band Linear Amplifier Instructions
ATTENTION !!!! The item is in compliance with CE regulations if it is
used toghether with 27/586 filter connecting the radio frequency output of the
unit an the antenna.
Instructions
-
Interruttore ON OFF lineare – Amplifier ON OFF switch
-
Connettore RTX – RTX connector.
Electronic switch.
Inversion polarity protection.
Receiving 26 dB antenna preamplifier, to be used also when the amplifier is
not working.
When using Amplifier KL 500 adjust it to assure a sufficient flow of air in
the aluminium dissipator. Use supply cables as short as possible not longer
than 3 meters, with a section of at least 6 mm² and directly connected to the
battery. Use a good quality Antenna, bearing at least 600 continuous Watt and
with SWR max 1.5/1. Don’t transmit for long without reasonable breaks enabling
transistors cooling. When using in base station a battery with floating
battery charger is advisable.
It is advisable not to use position six of the power selector when the input
power exceeds 12 W AM. Electronic switch.Inversion polarity protection. 24
months warranty except final transistors and estetical parts. Please note that
the use of linear amplifiers is ruled by specific laws, that are to be known
by the user, anyway the manufacturer declines any responsibility coming from
an uncorrected use. The use on 27 MHz is forbidden, remember that the use of
linear amplifier is ruled by specific law, that are to be know by the user,
anyway the manufactured declines any responsibility coming from an uncorrected
use. The use of this device is allowed only when the vehicle is not in motion.
http://www.rmitaly.com/
[email protected]